Penlaw soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 26 to 38 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Penlaw soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Penlaw silt loam (Lancaster County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 28% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (18).
- Raises the potential The official series description calls the wet soil slightly sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 12 in (31 cm)).
- Note Typically starts about 26 in (66 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 4% by volume).
Layer by layer
- Loamy layerH1 A silt loam layer about 0 to 10 in down: about 20% clay, moderate plasticity when wet, dark grayish brown when moist. Possible
- Loamy layerH2 A silty clay loam layer about 10 to 20 in down: about 28% clay, moderate plasticity when wet, yellowish brown when moist. Promising
- Loamy layerH3 A silty clay loam layer about 20 to 26 in down: about 28% clay, moderate plasticity when wet, yellowish brown when moist. Promising
- Loamy layerH4best layer A silty clay loam layer about 26 to 38 in down: about 28% clay, moderate plasticity when wet, yellowish brown when moist. Promising
- Loamy layerH5 A silty clay loam layer about 38 to 47 in down: about 28% clay, moderate plasticity when wet, yellowish brown when moist. Promising
- Loamy layerH6 A gravelly silty clay loam layer about 47 to 65 in down: about 33% clay, moderate plasticity when wet, brown when moist. Possible
What it looks like raw
The loamy layer (H4), 26 to 38 in down in the typical profile: yellowish brown (10YR 5/6); firm, brittle, slightly sticky, and plastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium derived from limestone, sandstone, and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: somewhat poorly drained.
- Lithic bedrock typically about 56 in (142 cm) down.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Pennsylvania, in these survey areas: Berks County, Pennsylvania; Chester County, Pennsylvania; Lancaster County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Pennsylvania and Maryland. The series is of moderate extent. Pennsylvania has about 15,000 acres.
USDA, geographic setting: Penlaw soils are on nearly level to sloping concave areas with slope gradients of 0 to 15 percent. Penlaw soils formed in colluvium derived largely from limestones but with some admixture of shale and sandstone. The climate is temperate and humid. Mean annual precipitation ranges from 35 to 50 inches, the mean annual temperature ranges from 50 to 58 degrees F., and the frost-free season ranges from 140 to 200 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Hagerstown: Strong lead
- Watchung: Strong lead
- Bowmansville: Promising
- Duffield: Promising
- Holly: Promising
- Joanna: Promising
- Mount Lucas: Promising
- Readington: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Penlaw silt loam, map unit Pa in Lancaster County, Pennsylvania.
- Official Series Description: Penlaw(revised 02/2008), established.
- Taxonomic class: Fine-silty, mixed, semiactive, mesic Aquic Fragiudalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.