Pedricktown soil
Wild-clay potential
Weak indication
Weak indication: no layer of Pedricktown shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Pedricktown soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Pedricktown spot on the map
Rated from the USDA soil survey record for Pedricktown, Askecksy, and Mullica soils, 0 to 2 percent slopes, rarely flooded (Salem County, New Jersey) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 4% clay.
- Lowers the potential Low engineering plasticity index (1): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 16 in (41 cm)).
- Lowers the potential Typically starts about 56 in (142 cm) down, deeper than most hand digging.
- Note Few rock fragments (about 0% by volume).
Layer by layer
- Organic top layerOe An organic top layer about 0 to 2 in down, not a clay body. Weak indication
- TopsoilAg A silt loam layer about 2 to 9 in down: about 10% clay, low plasticity when wet, black when moist. Weak indication
- Loamy layerCg1 A sandy loam layer about 9 to 22 in down: about 19% clay, moderate plasticity when wet, dark gray when moist. Weak indication
- Sandy layerCg2 A loamy sand layer about 22 to 36 in down: about 5% clay, low plasticity when wet, gray when moist. Weak indication
- Loamy layerCg3 A sandy clay loam layer about 36 to 40 in down: about 22% clay, moderate plasticity when wet, dark gray when moist. Weak indication
- Loamy layerCg4 A sandy loam layer about 40 to 49 in down: about 19% clay, moderate plasticity when wet, dark gray when moist. Weak indication
- Sandy layerCg5 A loamy sand layer about 49 to 56 in down: about 5% clay, low plasticity when wet, greenish gray when moist. Weak indication
- Sandy layerCg6best layer A sand layer about 56 to 72 in down: about 4% clay, low plasticity when wet, gray when moist. Weak indication
What it looks like raw
The sandy layer (Cg6), 56 to 72 in down in the typical profile: gray (2.5Y 5/1); sand; loose; nonsticky, nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: loamy and sandy fluviomarine deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: very poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in New Jersey, in these survey areas: Salem County, New Jersey.
By state: wild clay in New Jersey.
USDA, geographic setting: Landscape: Coastal Plain lowlands
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Adelphia: Possible
- Mannington: Possible
- Mattapex: Possible
- Othello: Possible
- Sassafras: Possible
- Sharptown: Possible
- Swedesboro: Possible
- Woodstown: Possible
See it on the map
Open a Pedricktown spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 45%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Pedricktown, Askecksy, and Mullica soils, 0 to 2 percent slopes, rarely flooded, map unit PEEAR in Salem County, New Jersey.
- Official Series Description: Pedricktown(revised 11/2002), established.
- Taxonomic class: Coarse-loamy, mixed, active, acid, mesic Humaqueptic Fluvaquents
- Rated with rule version 2026-09-28.1; the method is on the About page.