Pawtoot soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 13 to 32 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Pawtoot soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Pawtoot spot on the map
Rated from the USDA soil survey record for Pawtoot-Polecat complex, 3 to 12 percent slopes (Ada County, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 38% clay in the fine-earth portion.
- Note USDA labels this a "Btn2" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (28): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil very sticky and very plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 19 in (48 cm)).
- Note Typically starts within about 13 in (33 cm) of the surface.
- Note Few rock fragments (about 0% by volume).
- Note High shrink-swell (linear extensibility about 8.4%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- TopsoilA A silt loam layer about 0 to 2 in down: about 16% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerBA A silt loam layer about 2 to 6 in down: about 16% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerE A silt loam layer about 6 to 7 in down: about 15% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
- Clay subsoilBtn1 A clay layer about 7 to 13 in down: about 48% clay, high plasticity when wet, dark grayish brown when moist. Strong lead
- Clay subsoilBtn2best layer A silty clay loam layer about 13 to 32 in down: about 38% clay, high plasticity when wet, pale brown when moist. Strong lead
- Clay subsoilBtkn A silty clay loam layer about 32 to 41 in down: about 30% clay, high plasticity when wet, pale brown when moist. Promising
- Loamy layerBkny1 A silt loam layer about 41 to 56 in down: about 18% clay, moderate plasticity when wet, very pale brown when moist. Possible
- Loamy layerBkny2 A silt loam layer about 56 to 67 in down: about 18% clay, moderate plasticity when wet, very pale brown when moist. Weak indication
- BedrockCrky Bedrock about 67 to 77 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay subsoil (Btn2), 13 to 32 in down in the typical profile: pale brown (10YR 6/3), brown (10YR 4/3) moist; very hard, friable, very sticky and very plastic. Raw colour is not fired colour.
About the soil
- Parent material: silty and clayey alluvium over silty lacustrine deposits.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Idaho, in these survey areas: Ada County, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Ada County, Idaho. MLRA 10. The soils are of limited extent.
USDA, geographic setting: Pawtoot soils are on hill backslopes and footslopes and have slopes of 4 to 25 percent. The soils formed in slope alluvium and residuum from lacustrine deposits. The elevation ranges from 2,750 to 3,650 feet. The average annual precipitation is 12 to 16 inches and the average annual temperature is 50 to 51 degrees F. The frost-free period is 140 to 150 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aldape: Strong lead
- Aradaran: Strong lead
- Bowns: Strong lead
- Breadloaf: Strong lead
- Brent: Strong lead
- Castlerock: Strong lead
- Catchell: Strong lead
- Chardoton: Strong lead
See it on the map
Open a Pawtoot spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 45%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Pawtoot-Polecat complex, 3 to 12 percent slopes, map unit 3049 in Ada County, Idaho.
- Official Series Description: Pawtoot(revised 07/2012), established.
- Taxonomic class: Fine, smectitic, mesic Vertic Natrixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.