Paulmyers soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 10 to 23 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Paulmyers soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Paulmyers spot on the map
Rated from the USDA soil survey record for Paulmyers silt loam, 0 to 3 percent slopes (Ada County, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 33% clay in the fine-earth portion.
- Note USDA labels this a "Btk" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (23): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 13 in (33 cm)).
- Note Typically starts within about 10 in (25 cm) of the surface.
- Note Few rock fragments (about 2% by volume).
- Note USDA reports about 8% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilAp A silt loam layer about 0 to 10 in down: about 13% clay, moderate plasticity when wet, brown when moist. Weak indication
- Clay subsoilBtkbest layer A clay loam layer about 10 to 23 in down: about 33% clay, high plasticity when wet, pale brown when moist. Promising
- Sandy layerBk A loam layer about 23 to 58 in down: about 10% clay, low plasticity when wet, light gray when moist. Weak indication
- Sandy layer2C A fine gravelly coarse sandy loam layer about 58 to 65 in down: about 6% clay, low plasticity when wet. Weak indication
What it looks like raw
The clay subsoil (Btk), 10 to 23 in down in the typical profile: pale brown (10YR 6/3), dark brown (10YR 4/3) moist; hard, friable, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: mixed alluvium and/or lacustrine deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Idaho, in these survey areas: Ada County, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Ada, Minidoka, Twin Falls, Washington and Cassia Counties, Idaho. The series is moderately extensive.
USDA, geographic setting: Paulmyers soils are on terraces at elevations of 2,100 to 4,500 feet. Slopes range from 0 to 3 percent. The soils formed in somewhat stratified alluvium or possibly shallow lake-laid sediments of mixed mineralogy. The average annual air temperature is 45 to 52 degrees F. The mean annual precipitation is 8 to 12 inches, including 1 to 3 feet of snow. The frost-free period is 110 to 160 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aldape: Strong lead
- Aradaran: Strong lead
- Bowns: Strong lead
- Breadloaf: Strong lead
- Brent: Strong lead
- Castlerock: Strong lead
- Catchell: Strong lead
- Chardoton: Strong lead
See it on the map
Open a Paulmyers spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Paulmyers silt loam, 0 to 3 percent slopes, map unit 1 in Ada County, Idaho.
- Official Series Description: Paulmyers(revised 12/2022), established.
- Taxonomic class: Fine-loamy, mixed, superactive, mesic Aquic Calciargids
- Rated with rule version 2026-09-28.1; the method is on the About page.