Pass Canyon soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 11 to 20 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Pass Canyon soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Pass Canyon spot on the map
Rated from the USDA soil survey record for Pass Canyon-Rock outcrop complex, 6 to 30 percent slopes (Box Elder County, Utah, Eastern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 30% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (12.5).
- Raises the potential The official series description calls the wet soil slightly sticky and moderately plastic (a field observation, not a ceramic test).
- Note Moderate thickness (about 9 in (23 cm)).
- Note Typically starts within about 11 in (28 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 24% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilA11 A loam layer about 0 to 4 in down: about 14% clay, low plasticity when wet, brown when moist. Weak indication
- TopsoilA12 A silt loam layer about 4 to 11 in down: about 23% clay, moderate plasticity when wet, brown when moist. Possible
- Loamy layerB2tbest layer A cobbly clay loam layer about 11 to 20 in down: about 30% clay, moderate plasticity when wet, brown when moist. Possible
- BedrockR Unweathered bedrock about 20 to 30 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (B2t), 11 to 20 in down in the typical profile: brown (7.5YR 4/3), dark brown (7.5YR 3/4) moist; hard, firm, slightly sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium and residuum derived from quartzite and sandstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy.
- Drainage: well drained.
- Lithic bedrock typically about 20 in (51 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Utah, in these survey areas: Box Elder County, Utah, Eastern Part.
By state: wild clay in Utah.
USDA, distribution and extent: Southwestern Utah. This series is not extensive. MLRA 28A.
USDA, geographic setting: Parent material: residuum, slope alluvium, and colluvium over fractured intermediate igneous bedrock
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Collett: Strong lead
- Eimarsh: Strong lead
- Goring: Strong lead
- Lasil: Strong lead
- Manila: Strong lead
- Obray: Strong lead
- Payson: Strong lead
- Pintailake: Strong lead
See it on the map
Open a Pass Canyon spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 75%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Pass Canyon-Rock outcrop complex, 6 to 30 percent slopes, map unit POE in Box Elder County, Utah, Eastern Part.
- Official Series Description: Pass Canyon(revised 08/2013), established.
- Taxonomic class: Loamy, mixed, superactive, mesic Lithic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.