Parlo soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 19 to 31 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Parlo soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Parlo loam, 0 to 3 percent slopes (Morgan Area, Utah - Morgan County and Part of Weber County) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 26% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (12.5).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 12 in (31 cm)).
- Note Typically starts within about 19 in (48 cm) of the surface.
- Note Few rock fragments (about 11% by volume).
Layer by layer
- TopsoilA11, A12 A loam layer about 0 to 7 in down: about 20% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- TopsoilA13 A loam layer about 7 to 15 in down: about 20% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Loamy layerB1 A loam layer about 15 to 19 in down: about 20% clay, moderate plasticity when wet, brown when moist. Weak indication
- Loamy layerB2tbest layer A loam layer about 19 to 31 in down: about 26% clay, moderate plasticity when wet, pale brown when moist. Possible
- Loamy layerCk A very gravelly loam layer about 31 to 36 in down: about 20% clay, moderate plasticity when wet, pale brown when moist. Weak indication
- Sandy layerIIC2 An extremely gravelly loamy sand layer about 36 to 70 in down: about 3% clay, low plasticity when wet, pale brown when moist. Weak indication
What it looks like raw
The loamy layer (B2t), 19 to 31 in down in the typical profile: pale brown (10YR 6/3), brown (10YR 4/3) moist; hard, friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from limestone, sandstone and quartzite.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty over sandy or sandy-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Utah, in these survey areas: Morgan Area, Utah - Morgan County and Part of Weber County.
By state: wild clay in Utah.
USDA, distribution and extent: Lake terraces and stream terraces in northern Utah. This series is inextensive.
USDA, geographic setting: Parlo soils are on nearly level to strongly sloping, medium and high lake terraces or stream terraces and have slope gradients of 0 to 10 percent. They formed in mixed lake sediments and alluvium mainly from limestone, sandstone, and quartzite rocks. The climate is dry or moist subhumid. The mean annual temperature ranges from 45 to 52 degrees F. The mean summer temperature ranges from 65 to 73 degrees F. The frost-free period ranges from 100 to 150 days. The average annual precipitation ranges from 14 to 20 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Ant Flat: Strong lead
- Bertag: Strong lead
- Broadhead: Strong lead
- Crooked Creek: Strong lead
- Donner: Strong lead
- Hawkins: Strong lead
- Herd: Strong lead
- Isbell: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Parlo loam, 0 to 3 percent slopes, map unit PcA in Morgan Area, Utah - Morgan County and Part of Weber County.
- Official Series Description: Parlo(revised 03/2004), established.
- Taxonomic class: Fine-silty over sandy or sandy-skeletal, mixed, superactive, mesic Calcic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.