Palisade soil
Wild-clay potential
Weak indication
Weak indication: no layer of Palisade shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Palisade soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Palisade spot on the map
Rated from the USDA soil survey record for Palisade silt loam, 1 to 6 percent slopes (Box Elder County, Utah, Eastern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 16% clay.
- Lowers the potential Low engineering plasticity index (5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 17 in (43 cm)).
- Note Typically starts about 43 in (109 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 8% by volume).
- Note USDA reports about 15% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Sandy layerH1 A silt loam layer about 0 to 6 in down: about 16% clay, moderate plasticity when wet, pale brown when moist. Weak indication
- Sandy layerH2 A silt loam layer about 6 to 12 in down: about 16% clay, moderate plasticity when wet, very pale brown when moist. Weak indication
- Sandy layerH3 A silt loam layer about 12 to 19 in down: about 16% clay, moderate plasticity when wet, very pale brown when moist. Weak indication
- Sandy layerH4 A loam layer about 19 to 30 in down: about 16% clay, moderate plasticity when wet, light gray when moist. Weak indication
- Sandy layerH5 A very fine sandy loam layer about 30 to 43 in down: about 16% clay, low plasticity when wet, pale brown when moist. Weak indication
- Sandy layerH6best layer A very fine sandy loam layer about 43 to 60 in down: about 16% clay, low plasticity when wet, pale brown when moist. Weak indication
What it looks like raw
The sandy layer (H6), 43 to 60 in down in the typical profile: pale brown (10YR6/3), brown (10YR 4/3) moist; soft, friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: lacustrine deposits derived from limestone and sandstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Utah, in these survey areas: Box Elder County, Utah, Eastern Part.
By state: wild clay in Utah.
USDA, distribution and extent: Northwestern Utah. These soils are moderately extensive. MLRA 28A.
USDA, geographic setting: Palisade soils are on lake terraces. These soils formed in lacustrine deposits derived from limestone and sandstone. Slopes are 1 to 10 percent. The mean annual precipitation is 8 to 12 inches, the mean annual temperature is 46 to 52 degrees F., and the freeze-free period is 90 to 130 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Collett: Strong lead
- Eimarsh: Strong lead
- Goring: Strong lead
- Lasil: Strong lead
- Manila: Strong lead
- Obray: Strong lead
- Payson: Strong lead
- Pintailake: Strong lead
See it on the map
Open a Palisade spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Palisade silt loam, 1 to 6 percent slopes, map unit PAB in Box Elder County, Utah, Eastern Part.
- Official Series Description: Palisade(revised 05/2005), established.
- Taxonomic class: Coarse-loamy, mixed, active, mesic Sodic Xeric Haplocalcids
- Rated with rule version 2026-09-28.1; the method is on the About page.