Norcan soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 21 to 44 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Norcan soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Norcan loam, 30 to 60 percent slopes (Morgan Area, Utah - Morgan County and Part of Weber County) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 45% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (22.5): USDA's estimate suggests plastic behavior when wet.
- Note Thick enough to investigate (about 23 in (59 cm)).
- Note Typically starts within about 21 in (53 cm) of the surface.
- Note Few rock fragments (about 8% by volume).
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
Layer by layer
- TopsoilA11, A12 A loam layer about 0 to 15 in down: about 23% clay, moderate plasticity when wet, dark reddish brown when moist. Weak indication
- Clay-rich layerB21t A clay loam layer about 15 to 21 in down: about 38% clay, moderate plasticity when wet, dark reddish brown when moist. Strong lead
- Clay-rich layerB22tbest layer A clay layer about 21 to 44 in down: about 45% clay, high plasticity when wet, dark red when moist. Strong lead
- Clay-rich layerB23t A silty clay loam layer about 44 to 60 in down: about 38% clay, moderate plasticity when wet, dark red when moist. Strong lead
What it looks like raw
The clay-rich layer (B22t), 21 to 44 in down in the typical profile: dark red (2.5YR 3/6), red (2.5YR 4/6) dry. Raw colour is not fired colour.
About the soil
- Parent material: colluvium derived from sandstone.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Utah, in these survey areas: Morgan Area, Utah - Morgan County and Part of Weber County.
By state: wild clay in Utah.
USDA, geographic setting: Norcan soils are at elevations of 5,200 to 7,500 feet. They occur on concave north-facing mountain slopes. Slopes range from 30 to 60 percent. These soils formed in residuum and local alluvium weathered from sandstone. The climate is moist subhumid and the average annual precipitation ranges from 20 to 25 inches. The mean annual temperature is 41 to 44 degrees F. The mean summer temperature is 58 to 62 degrees F. and the frost-free priod ranges from 60 to 80 days. PRINCIPAL ASSOCIATED SOILS: These are the Ercan, Hawkins, Henhoit, Hoskin, Morgala, Moweba, Nordic and Ostler soils. Ercan and Nordic soils have summer temperature of less than 59 degrees F., have A2 horizons and have argillic...
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Ant Flat: Strong lead
- Bertag: Strong lead
- Broadhead: Strong lead
- Crooked Creek: Strong lead
- Donner: Strong lead
- Hawkins: Strong lead
- Herd: Strong lead
- Isbell: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Norcan loam, 30 to 60 percent slopes, map unit NtG in Morgan Area, Utah - Morgan County and Part of Weber County.
- Official Series Description: Norcan, established.
- Taxonomic class: Fine, smectitic, frigid Typic Palexerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.