Murrill soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 11 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Murrill soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Murrill spot on the map
Rated from the USDA soil survey record for Murrill gravelly silt loam, 3 to 8 percent slopes (Lebanon County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 30% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (15).
- Raises the potential The official series description calls the wet soil slightly sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 49 in (124 cm)).
- Note Typically starts within about 11 in (28 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 25% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Sandy layerH1 A channery silt loam layer about 0 to 11 in down: about 15% clay, moderate plasticity when wet, dark yellowish brown when moist. Weak indication
- Loamy layerH2best layer A channery silty clay loam layer about 11 to 60 in down: about 30% clay, moderate plasticity when wet, strong brown when moist. Possible
- Loamy layerH3 A gravelly sandy clay loam layer about 60 to 64 in down: about 33% clay, high plasticity when wet, reddish brown when moist. Weak indication
What it looks like raw
The loamy layer (H2), 11 to 60 in down in the typical profile: strong brown (7.5YR 5/6); firm, slightly sticky, plastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium derived from sandstone over residuum weathered from limestone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
- Lithic bedrock typically about 85 in (217 cm) down.
Where it is mapped
Seen on the map as the most common soil in 15 map units in Pennsylvania, in these survey areas: Berks County, Pennsylvania; Centre County, Pennsylvania; Chester County, Pennsylvania; Lancaster County, Pennsylvania; Lebanon County, Pennsylvania; Lehigh County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Pennsylvania, Maryland, West Virginia, and Virginia. This series is of large extent.
USDA, geographic setting: Murrill soils are on lower backslopes, footslopes, fans, and benches. Most landscape surfaces are concave, and sinkholes in karst topography are common features. Slope ranges from 0 to 55 percent. The soil formed in colluvium derived from acid sandstones and shales with some components of limestone or highly calcareous shales over residuum of limestone. The mean annual precipitation ranges from 35 to 45 inches. Mean annual air temperature ranges from 48 to 56 degrees F.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Hagerstown: Strong lead
- Watchung: Strong lead
- Dunning: Strong lead
- Hublersburg: Strong lead
- Millheim: Strong lead
- Opequon: Strong lead
- Bowmansville: Promising
- Duffield: Promising
See it on the map
Open a Murrill spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Murrill gravelly silt loam, 3 to 8 percent slopes, map unit MuB in Lebanon County, Pennsylvania.
- Official Series Description: Murrill(revised 12/2008), established.
- Taxonomic class: Fine-loamy, mixed, semiactive, mesic Typic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.