Moulton soil
Wild-clay potential
Weak indication
Weak indication: no layer of Moulton shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Moulton soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Moulton spot on the map
Rated from the USDA soil survey record for Moulton loamy sand, 0 to 1 percent slopes (Canyon Area, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 8% clay.
- Lowers the potential Low engineering plasticity index (4): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 39 in (99 cm)).
- Note Typically starts within about 21 in (53 cm) of the surface.
- Lowers the potential High rock content (about 41% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- TopsoilA A loamy sand layer about 0 to 3 in down: about 8% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerBg A fine sandy loam layer about 3 to 21 in down: about 15% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Sandy layer2Cbest layer A very gravelly sand layer about 21 to 60 in down: about 8% clay, low plasticity when wet, light brownish gray when moist. Weak indication
What it looks like raw
The sandy layer (2C), 21 to 60 in down in the typical profile: light brownish gray (2.5Y 6/2) moist; loose. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from igneous rock.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy over sandy or sandy-skeletal.
- Drainage: poorly drained.
Where it is mapped
Seen on the map as the most common soil in 8 map units in Idaho, in these survey areas: Ada County, Idaho; Canyon Area, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Southwestern Idaho and possibly southeastern Oregon. The series is of moderate extent.
USDA, geographic setting: The Moulton soils are on flood plains, low terraces, and low alluvial fans at elevations of 2,100 to 4,500 feet. Slopes are dominantly less than 1 percent and range from 0 to 3 percent. The soils formed in recent alluvium dominantly from granitic material and a small amount from basalt. The average annual temperature is 45 to 52 degrees. The frost-free period ranges from 140 to 160 days, and the average annual precipitation ranges from 8 to 12 inches, including 1.5 to 3 feet of snow.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aldape: Strong lead
- Aradaran: Strong lead
- Bowns: Strong lead
- Breadloaf: Strong lead
- Brent: Strong lead
- Castlerock: Strong lead
- Catchell: Strong lead
- Chardoton: Strong lead
See it on the map
Open a Moulton spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Moulton loamy sand, 0 to 1 percent slopes, map unit MoA in Canyon Area, Idaho.
- Official Series Description: Moulton(revised 05/2001), established.
- Taxonomic class: Coarse-loamy over sandy or sandy-skeletal, mixed, superactive, mesic Typic Endoaquolls
- Rated with rule version 2026-09-28.1; the method is on the About page.