Montezuma soil
Wild-clay potential
Weak indication
Weak indication: no layer of Montezuma shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Montezuma soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Montezuma spot on the map
Rated from the USDA soil survey record for Montezuma-Ota association, 4 to 50 percent slopes (Ada County, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 5% clay.
- Lowers the potential Low engineering plasticity index (2): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 18 in (45 cm)).
- Note Typically starts about 42 in (107 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 70% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
- Note USDA reports about 20% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilA A sandy loam layer about 0 to 4 in down: about 17% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
- Loamy layerBA A loam layer about 4 to 9 in down: about 20% clay, moderate plasticity when wet, light gray when moist. Weak indication
- Loamy layerBw A loam layer about 9 to 14 in down: about 22% clay, moderate plasticity when wet, light gray when moist. Weak indication
- Loamy layerBq1 A paragravelly ashy loam layer about 14 to 24 in down: about 22% clay, moderate plasticity when wet, light gray when moist. Weak indication
- Sandy layerBq2 A very gravelly ashy loam layer about 24 to 32 in down: about 16% clay, moderate plasticity when wet, light gray when moist. Weak indication
- Sandy layerBkq1 A very gravelly ashy sandy loam layer about 32 to 38 in down: about 14% clay, moderate plasticity when wet, light gray when moist. Weak indication
- Bkqm A cemented material layer about 38 to 42 in down: USDA gives no clay percentage or texture for it. Not enough data
- Sandy layerBkq2best layer An extremely gravelly ashy loamy sand layer about 42 to 60 in down: about 5% clay, low plasticity when wet, light gray when moist. Weak indication
What it looks like raw
The sandy layer (Bkq2), 42 to 60 in down in the typical profile: light gray (10YR 7/2), pale brown (10YR 6/3) moist; soft, very friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: volcanic ash and/or colluvium derived from pumice.
- USDA family particle-size class: ashy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Idaho, in these survey areas: Ada County, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: East-central California. The soils are of small extent in MLRA - 26.
USDA, geographic setting: Montezuma soils are on fan terraces at elevations of 1,650 to 2,230 meters. Slopes are 2 to 9 percent. The soils formed in rhyolithic ashy alluvium. The mean annual precipitation is 15 to 25 cm. Mean January temperature is about 0 degrees C; mean July temperature is about 21 degrees C; mean annual temperature is 8 to 10 degrees C. The frost-free season is 125 to 150 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aldape: Strong lead
- Aradaran: Strong lead
- Bowns: Strong lead
- Breadloaf: Strong lead
- Brent: Strong lead
- Castlerock: Strong lead
- Catchell: Strong lead
- Chardoton: Strong lead
See it on the map
Open a Montezuma spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 60%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Montezuma-Ota association, 4 to 50 percent slopes, map unit 4100 in Ada County, Idaho.
- Official Series Description: Montezuma(revised 01/2023), established.
- Taxonomic class: Ashy, glassy, mesic Vitrixerandic Haplodurids
- Rated with rule version 2026-09-28.1; the method is on the About page.