Mispillion soil
Wild-clay potential
Weak indication
Weak indication: no layer of Mispillion shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Mispillion soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Mispillion spot on the map
Rated from the USDA soil survey record for Mispillion and Transquaking soils, tidally flooded (Charles County, Maryland) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 20% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (15).
- Note The official series description calls the wet soil moderately sticky and slightly plastic.
- Note Thick enough to investigate (about 26 in (66 cm)).
- Lowers the potential Typically starts about 54 in (137 cm) down, deeper than most hand digging.
- Note Few rock fragments (about 0% by volume).
Layer by layer
- Organic top layerOe An organic top layer about 0 to 24 in down, not a clay body. Weak indication
- Organic top layerOa An organic top layer about 24 to 40 in down, not a clay body. Weak indication
- Loamy layerCg1 A mucky silt loam layer about 40 to 54 in down: about 25% clay, moderate plasticity when wet, black when moist. Weak indication
- Loamy layerCg2best layer A silt loam layer about 54 to 80 in down: about 20% clay, moderate plasticity when wet, dark gray when moist. Weak indication
What it looks like raw
The loamy layer (Cg2), 54 to 80 in down in the typical profile: dark gray (N 4/); moderately sticky, slightly plastic; very fluid. Raw colour is not fired colour.
About the soil
- Parent material: herbaceous organic material over silty estuarine sediments.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy.
- Drainage: very poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Maryland, in these survey areas: Baltimore County, Maryland; Charles County, Maryland; Prince George's County, Maryland.
By state: wild clay in Maryland.
USDA, distribution and extent: General area--Tidal salt marshes of the mid-Atlantic coastal plain within the states of Maryland, Delaware, and New Jersey
USDA, geographic setting: Parent material--Herbaceous organic deposits over loamy estuarine deposits
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Christiana: Strong lead
- Lenni: Strong lead
- Magnolia: Strong lead
- Benevola: Strong lead
- Cumberstone: Strong lead
- Howell: Strong lead
- Jackland: Strong lead
- Montalto: Strong lead
See it on the map
Open a Mispillion spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 41%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Mispillion and Transquaking soils, tidally flooded, map unit MT in Charles County, Maryland.
- Official Series Description: Mispillion(revised 03/2025), established.
- Taxonomic class: Loamy, mixed, euic, mesic Terric Sulfihemists
- Rated with rule version 2026-09-28.1; the method is on the About page.