McLoughlin soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 28 to 50 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about McLoughlin soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a McLoughlin spot on the map
Rated from the USDA soil survey record for McLoughlin silt loam, 0 to 2 percent slopes (Malheur County, Oregon, Northeastern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 31% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (13).
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 22 in (56 cm)).
- Note Typically starts about 28 in (71 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
- Note USDA reports about 25% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilAp1 A silt loam layer about 0 to 3 in down: about 24% clay, low plasticity when wet, very pale brown when moist. Weak indication
- TopsoilAp2 A silt loam layer about 3 to 9 in down: about 24% clay, low plasticity when wet, very pale brown when moist. Weak indication
- Loamy layerBw A silt loam layer about 9 to 20 in down: about 24% clay, low plasticity when wet, very pale brown when moist. Weak indication
- Loamy layerBCk1 A silty clay loam layer about 20 to 28 in down: about 31% clay, moderate plasticity when wet, very pale brown when moist. Promising
- Loamy layerBCk2best layer A silty clay loam layer about 28 to 50 in down: about 31% clay, moderate plasticity when wet, very pale brown when moist. Promising
- Loamy layerC A stratified silty clay loam to silt loam layer about 50 to 60 in down: about 31% clay, moderate plasticity when wet. Possible
What it looks like raw
The loamy layer (BCk2), 28 to 50 in down in the typical profile: very pale brown (10YR 7/3), yellowish brown (10YR 4/4) moist; hard, friable, sticky and plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 5 map units in Oregon, in these survey areas: Malheur County, Oregon, Northeastern Part; Malheur County, Oregon, Northern Part.
By state: wild clay in Oregon.
USDA, distribution and extent: Malheur County, Oregon. Over 5,000 feet in Utah. The series is inextensive.
USDA, geographic setting: McLoughlin soils are on nearly level to gently sloping alluvial fans with gradients of 0 to 8 percent, at elevations of 2,100 to 3,500 feet. The soils formed in mixed alluvium from old lacustrine sediments. The climate is semiarid with hot dry summers and cold moist winters. The mean annual temperature is about 46 to 54 degrees F., mean summer temperature is 68 to 72 degrees F., and mean winter temperature is 31 to 33 degrees F. The average annual precipitation ranges from 8 to 10 inches. The frost-free period is 110 to 170 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Poall: Strong lead
- Ratsnest: Strong lead
- Ruclick: Possible
- Frohman: Weak indication
- Nyssa: Weak indication
- Turbyfill: Weak indication
- Cencove: Weak indication
- Drewsey: Weak indication
See it on the map
Open a McLoughlin spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for McLoughlin silt loam, 0 to 2 percent slopes, map unit 19A in Malheur County, Oregon, Northeastern Part.
- Official Series Description: McLoughlin(revised 10/2002), established.
- Taxonomic class: Fine-silty, mixed, superactive, mesic Xeric Haplocambids
- Rated with rule version 2026-09-28.1; the method is on the About page.