Ruclick soil
Wild-clay potential
Possible
Possible: a clay-enriched layer typically about 10 to 21 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Ruclick soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Ruclick spot on the map
Rated from the USDA soil survey record for Ruclick-Bakeoven-Ruckles complex, 8 to 40 percent slopes (Malheur County, Oregon, Northern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 42% clay in the fine-earth portion.
- Note USDA labels this a "Bt1" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (31): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil very sticky and very plastic (a field observation, not a ceramic test).
- Note Moderate thickness (about 11 in (28 cm)).
- Note Typically starts within about 10 in (25 cm) of the surface.
- Lowers the potential High rock content (about 45% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- TopsoilA A cobbly loam layer about 0 to 5 in down: about 20% clay, moderate plasticity when wet, brown when moist. Weak indication
- Loamy layerBA A cobbly clay loam layer about 5 to 10 in down: about 30% clay, high plasticity when wet, brown when moist. Weak indication
- Clay subsoilBt1best layer A very gravelly clay layer about 10 to 21 in down: about 42% clay, high plasticity when wet, pale brown when moist. Possible
- Clay subsoilBt2 An extremely gravelly clay layer about 21 to 29 in down: about 42% clay, high plasticity when wet, pale brown when moist. Possible
- BedrockR Bedrock about 29 to 79 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay subsoil (Bt1), 10 to 21 in down in the typical profile: pale brown (10YR 6/3), brown (10YR 4/3) moist; very hard, firm, very sticky and very plastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium over residuum weathered from volcanic rock.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: clayey-skeletal.
- Drainage: well drained.
- Lithic bedrock typically about 29 in (74 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Oregon, in these survey areas: Malheur County, Oregon, Northern Part.
By state: wild clay in Oregon.
USDA, distribution and extent: Southwestern Idaho, California and Oregon. MLRA 25, 21. Ruclick soils are of moderate extent.
USDA, geographic setting: Ruclick soils are on summits, dipslopes, and sideslopes of foothills and tablelands at elevations of 4,000 to 6,500 feet in Idaho, and as low as 1,200 feet in Oregon. Slopes range from 0 to 70 percent. These soils formed in alluvium, colluvium,and residuum from basalt, welded tuff and volcanic ash. The climate is cool and moist in the winter and hot and dry in the summer. Average annual precipitation ranges from 11 to 14 inches and as low as 9 inches in Oregon. The average annual temperature ranges from 45 to 53 degrees F. The frost-free period is 80 to 160 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Poall: Strong lead
- Ratsnest: Strong lead
- McLoughlin: Promising
- Cencove: Weak indication
- Drewsey: Weak indication
- Frohman: Weak indication
- Haar: Weak indication
- Joseph: Weak indication
See it on the map
Open a Ruclick spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 45%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Ruclick-Bakeoven-Ruckles complex, 8 to 40 percent slopes, map unit 8006 in Malheur County, Oregon, Northern Part.
- Official Series Description: Ruclick(revised 06/2013), established.
- Taxonomic class: Clayey-skeletal, smectitic, mesic Aridic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.