Cencove soil
Wild-clay potential
Weak indication
Weak indication: no layer of Cencove shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Cencove soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Cencove spot on the map
Rated from the USDA soil survey record for Cencove fine sandy loam, 0 to 1 percent slopes (Canyon Area, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 3% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 28 in (71 cm)).
- Note Typically starts about 32 in (81 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential Noticeable rock fragments (about 31% by volume); screening would be needed and the clay percentage applies to the fine earth only.
- Note USDA reports about 23% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilAp A fine sandy loam layer about 0 to 9 in down: about 8% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layerBk A fine sandy loam layer about 9 to 32 in down: about 12% clay, moderate plasticity when wet, light gray when moist. Weak indication
- Sandy layer2Cbest layer A gravelly sand layer about 32 to 60 in down: about 3% clay, low plasticity when wet, light brownish gray when moist. Weak indication
What it looks like raw
The sandy layer (2C), 32 to 60 in down in the typical profile: light brownish gray (10YR 6/2), dark grayish brown (10YR 4/2) moist; loose. Raw colour is not fired colour.
About the soil
- Parent material: mixed alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy over sandy or sandy-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 6 map units in Idaho, Oregon, in these survey areas: Canyon Area, Idaho; Malheur County, Oregon, Northern Part.
By state: wild clay in Idaho,wild clay in Oregon.
USDA, distribution and extent: Southern Idaho and eastern Oregon. Moderately extensive.
USDA, geographic setting: Cencove soils are on level to sloping alluvial fans and terraces. Slopes range from 0 to 12 percent but are predominantly less than 4 percent. Elevations range from 2,000 to 4,500 feet. The soils formed in mixed alluvium derived mostly from quartzitic, granitic, rhyolitic, basaltic, and Idaho-Payette formation materials. The climate is semiarid, continental with dry summers. Average frost-free period is 110 to 170 days, mean annual precipitation is 7 to 11 inches, including 0.5 to 2 feet of snow.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Poall: Strong lead
- Ratsnest: Strong lead
- Catherine: Promising
- Elijah: Promising
- Greenleaf: Promising
- McLoughlin: Promising
- Nannyton: Promising
- Baldock: Possible
See it on the map
Open a Cencove spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Cencove fine sandy loam, 0 to 1 percent slopes, map unit CcA in Canyon Area, Idaho.
- Official Series Description: Cencove(revised 10/2002), established.
- Taxonomic class: Coarse-loamy over sandy or sandy-skeletal, mixed, superactive, calcareous, mesic Xeric Torriorthents
- Rated with rule version 2026-09-28.1; the method is on the About page.