Baldock soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 16 to 27 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Baldock soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Baldock spot on the map
Rated from the USDA soil survey record for Baldock loam, 0 to 1 percent slopes (Canyon Area, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 23% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (15).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Moderate thickness (about 11 in (28 cm)).
- Note Typically starts within about 16 in (41 cm) of the surface.
- Note Few rock fragments (about 6% by volume).
- Note USDA reports about 10% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilAk A loam layer about 0 to 16 in down: about 17% clay, moderate plasticity when wet, gray when moist. Weak indication
- Loamy layerBkbest layer A loam layer about 16 to 27 in down: about 23% clay, moderate plasticity when wet, light brownish gray when moist. Possible
- Sandy layerC A fine sandy loam layer about 27 to 60 in down: about 10% clay, low plasticity when wet, light brownish gray when moist. Weak indication
What it looks like raw
The loamy layer (Bk), 16 to 27 in down in the typical profile: light brownish gray (2.5Y 6/2), dark grayish brown (2.5Y 4/2) moist; slightly hard, very friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: mixed alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Idaho, in these survey areas: Ada County, Idaho; Canyon Area, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Valleys of eastern Oregon and southern Idaho. The series is moderately extensive.
USDA, geographic setting: Baldock soils are on alluvial fans, floodplains, lake basins, and low terraces at elevations of 2,000 to 4,500 feet. The soils formed in mixed alluvium. Slope is dominantly less than 1 percent but ranges to 4 percent. Average annual temperature is 46 to 52 degrees F and average annual precipitation is 6 to 12 inches including 0.5 to 3.0 feet of snow. Summers are dry. The average frost-free period is 110 to 160 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aldape: Strong lead
- Aradaran: Strong lead
- Bowns: Strong lead
- Breadloaf: Strong lead
- Brent: Strong lead
- Castlerock: Strong lead
- Catchell: Strong lead
- Chardoton: Strong lead
See it on the map
Open a Baldock spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Baldock loam, 0 to 1 percent slopes, map unit BdA in Canyon Area, Idaho.
- Official Series Description: Baldock(revised 05/2001), established.
- Taxonomic class: Fine-loamy, mixed, superactive, mesic Typic Calciaquolls
- Rated with rule version 2026-09-28.1; the method is on the About page.