Poall soil
Wild-clay potential
Strong lead
Strong lead: a clay-enriched layer typically about 15 to 25 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Poall soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Power-Poall complex, 2 to 25 percent slopes (Malheur County, Oregon, Northern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 38% clay in the fine-earth portion.
- Note USDA labels this a "2Bt2" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (27): USDA's estimate suggests plastic behavior when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Moderate thickness (about 10 in (26 cm)).
- Note Typically starts within about 15 in (38 cm) of the surface.
- Note Few rock fragments (about 0% by volume).
- Note High shrink-swell (linear extensibility about 6.9%): often very plastic, and prone to cracking as it dries.
Layer by layer
- TopsoilA1 A very fine sandy loam layer about 0 to 3 in down: about 15% clay, moderate plasticity when wet, brown when moist. Weak indication
- TopsoilA2 A very fine sandy loam layer about 3 to 9 in down: about 15% clay, moderate plasticity when wet, pale brown when moist. Weak indication
- Clay subsoil2Bt1 A clay layer about 9 to 15 in down: about 42% clay, high plasticity when wet, brown when moist. Strong lead
- Clay subsoil2Bt2best layer A silty clay loam layer about 15 to 25 in down: about 38% clay, high plasticity when wet, brown when moist. Strong lead
- Loamy layer3Bk1 A very fine sandy loam layer about 25 to 41 in down: about 18% clay, moderate plasticity when wet, light yellowish brown when moist. Weak indication
- Loamy layer3Bk2 A very fine sandy loam layer about 41 to 60 in down: about 18% clay, moderate plasticity when wet, very pale brown when moist. Weak indication
What it looks like raw
The clay subsoil (2Bt2), 15 to 25 in down in the typical profile: brown (10YR 5/3), dark brown (10YR 3/3) moist; hard, friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: loess over alluvium derived from igneous and sedimentary rock.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Oregon, in these survey areas: Malheur County, Oregon, Northern Part.
By state: wild clay in Oregon.
USDA, distribution and extent: Southeastern Oregon. The series is inextensive.
USDA, geographic setting: Poall soils are on hills. They formed in lacustrine sediments. Slope ranges from 2 to 40 percent. Elevation is 2,200 to 4,200 feet. The climate is characterized by cold moist winters and warm dry summers. The mean annual temperature is 45 to 52 degrees F. The mean annual precipitation is 8 to 12 inches. The frost-free period is 80 to 140 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Ratsnest: Strong lead
- McLoughlin: Promising
- Ruclick: Possible
- Cencove: Weak indication
- Drewsey: Weak indication
- Frohman: Weak indication
- Haar: Weak indication
- Joseph: Weak indication
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 55%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Power-Poall complex, 2 to 25 percent slopes, map unit 4015 in Malheur County, Oregon, Northern Part.
- Official Series Description: Poall, established.
- Taxonomic class: Fine, smectitic, mesic Xeric Paleargids
- Rated with rule version 2026-09-28.1; the method is on the About page.