Nannyton soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 7 to 14 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Nannyton soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Nannyton spot on the map
Rated from the USDA soil survey record for Nannyton fine gravelly sandy loam, 1 to 3 percent slopes (Canyon Area, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 30% clay in the fine-earth portion.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (21): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Moderate thickness (about 7 in (18 cm)).
- Note Typically starts within about 7 in (18 cm) of the surface.
- Note Few rock fragments (about 10% by volume).
Layer by layer
- TopsoilA A fine gravelly sandy loam layer about 0 to 7 in down: about 6% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- Clay subsoilBtbest layer A clay loam layer about 7 to 14 in down: about 30% clay, high plasticity when wet, light gray when moist. Promising
- Loamy layerBk1 A loam layer about 14 to 17 in down: about 23% clay, moderate plasticity when wet, light gray when moist. Weak indication
- Sandy layerBk2 A fine sandy loam layer about 17 to 23 in down: about 12% clay, moderate plasticity when wet, very pale brown when moist. Weak indication
- Sandy layer2Bk3 A gravelly coarse sandy loam layer about 23 to 27 in down: about 10% clay, low plasticity when wet, very pale brown when moist. Weak indication
- Sandy layer3Bk4 A gravelly loamy coarse sand layer about 27 to 39 in down: about 7% clay, low plasticity when wet, light gray when moist. Weak indication
- Sandy layer4Bk5 A stratified sand to gravel layer about 39 to 60 in down: about 1% clay, low plasticity when wet, light gray when moist. Weak indication
What it looks like raw
The clay subsoil (Bt), 7 to 14 in down in the typical profile: light gray (10YR 7/2), brown (10YR 5/3); when; slightly hard, friable, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from rhyolite.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Idaho, in these survey areas: Canyon Area, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Southwestern Idaho; MLRA 11. Not extensive.
USDA, geographic setting: Nannyton soils are on level to moderately sloping alluvial fans and terraces at elevations of 2,300 to 2,500 feet. Slopes range from 0 to 8 percent. The soils formed in alluvium dominantly from rhyolitic, granitic, and basaltic sources. The climate is arid with very dry summers. Average annual precipitation is 6 to 9 inches, including a little snowfall. Average annual temperature is 53 to 54 degrees F. The frost-free period is 145 to 160 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Catherine: Promising
- Elijah: Promising
- Greenleaf: Promising
- Baldock: Possible
- Chance: Possible
- Draper: Possible
- Harpt: Possible
- Lankbush: Possible
See it on the map
Open a Nannyton spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Nannyton fine gravelly sandy loam, 1 to 3 percent slopes, map unit NaB in Canyon Area, Idaho.
- Official Series Description: Nannyton(revised 05/2000), established.
- Taxonomic class: Fine-loamy, mixed, superactive, mesic Typic Calciargids
- Rated with rule version 2026-09-28.1; the method is on the About page.