Harpt soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 22 to 44 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Harpt soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Harpt loam (Canyon Area, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 21% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (14).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 22 in (56 cm)).
- Note Typically starts within about 22 in (56 cm) of the surface.
- Note Few rock fragments (about 4% by volume).
Layer by layer
- TopsoilA A loam layer about 0 to 22 in down: about 17% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Loamy layerC1best layer A sandy clay loam layer about 22 to 44 in down: about 21% clay, moderate plasticity when wet, grayish brown when moist. Possible
- Sandy layer2C2 A gravelly coarse sandy loam layer about 44 to 60 in down: about 10% clay, low plasticity when wet, light brownish gray when moist. Weak indication
What it looks like raw
The loamy layer (C1), 22 to 44 in down in the typical profile: grayish brown (10YR 5/2), very dark grayish brown (10YR 3/2) moist; slightly hard, friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: mixed alluvium and/or lacustrine deposits and/or loess.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Idaho, in these survey areas: Ada County, Idaho; Canyon Area, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Southwestern Idaho and possibly Oregon, and Nevada. Moderately extensive.
USDA, geographic setting: The Harpt soils are on alluvial fans at elevations of 2,000 to 4,500 feet. The soil formed in recent alluvium derived mainly from acid igneous rocks. Slopes are 0 to 30 percent. The climate is semiarid and summers are dry. The frost-free period is 120 to 160 days, and the average annual precipitation is 9 to 13 inches, including 1.5 to 4 feet of snowfall. Average annual air temperature is 45 to 52 degrees F.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aldape: Strong lead
- Aradaran: Strong lead
- Bowns: Strong lead
- Breadloaf: Strong lead
- Brent: Strong lead
- Castlerock: Strong lead
- Catchell: Strong lead
- Chardoton: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Harpt loam, map unit Ha in Canyon Area, Idaho.
- Official Series Description: Harpt(revised 10/2002), established.
- Taxonomic class: Fine-loamy, mixed, superactive, mesic Torrifluventic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.