Martini soil
Wild-clay potential
Weak indication
Weak indication: no layer of Martini shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Martini soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Martini spot on the map
Rated from the USDA soil survey record for Martini fine sandy loam, 0 to 1 percent slopes (Davis-Weber Area, Utah) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 9% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil slightly sticky and nonplastic.
- Note Thick enough to investigate (about 51 in (130 cm)).
- Note Typically starts within about 19 in (48 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note USDA reports about 9% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilA11 A fine sandy loam layer about 0 to 5 in down: about 9% clay, low plasticity when wet, grayish brown when moist. Weak indication
- TopsoilA12 A fine sandy loam layer about 5 to 15 in down: about 9% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerC1 A fine sand layer about 15 to 19 in down: about 6% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerC2best layer A fine sandy loam layer about 19 to 70 in down: about 9% clay, low plasticity when wet, grayish brown when moist. Weak indication
What it looks like raw
The sandy layer (C2), 19 to 70 in down in the typical profile: grayish brown (10YR 5/2); fine sandy loam stratified with thin lenses of fine sand; soft, very friable, slightly sticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Utah, in these survey areas: Davis-Weber Area, Utah.
By state: wild clay in Utah.
USDA, distribution and extent: Northwestern Utah. These soils are not extensive with about 3,000 acres of the series mapped to date. MLRA 28A.
USDA, geographic setting: Martini soils are on flood plains. These soils formed in alluvium derived dominantly from quartzite, sandstone, limestone, and granite. Slopes are 0 to 2 percent. Elevations range from 4,200 to 4,600 feet. The climate is dry subhumid. The mean annual precipitation is 12 to 18 inches. The mean annual air temperature is 46 to 52 degrees F. and the mean summer air temperature is 66 to 73 degrees F. The frost-free period is 130 to 180 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Abbott: Strong lead
- Airport: Strong lead
- Eimarsh: Strong lead
- Kirkham: Strong lead
- Payson: Strong lead
- Pintailake: Strong lead
- Saltair: Strong lead
- Woods Cross: Strong lead
See it on the map
Open a Martini spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 95%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Martini fine sandy loam, 0 to 1 percent slopes, map unit MrA in Davis-Weber Area, Utah.
- Official Series Description: Martini(revised 12/2006), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, mesic Fluventic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.