Madawaska soil
Wild-clay potential
Weak indication
Weak indication: no layer of Madawaska shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Madawaska soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Madawaska spot on the map
Rated from the USDA soil survey record for Madawaska very fine sandy loam, 0 to 3 percent slopes (Coos County Area, New Hampshire) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 3% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 35 in (89 cm)).
- Note Typically starts about 30 in (76 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 7% by volume).
Layer by layer
- Sandy layerH1 A very fine sandy loam layer about 0 to 8 in down: about 8% clay, low plasticity when wet, dark brown when moist. Weak indication
- Sandy layerH2 A very fine sandy loam layer about 8 to 30 in down: about 7% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layerH3best layer A fine sand layer about 30 to 65 in down: about 3% clay, low plasticity when wet, light brownish gray when moist. Weak indication
What it looks like raw
The sandy layer (H3), 30 to 65 in down in the typical profile: light brownish gray (2.5Y 6/2); loose. Raw colour is not fired colour.
About the soil
- Parent material: loamy outwash over sandy and/or gravelly outwash derived from granite and gneiss or schist.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy over sandy or sandy-skeletal.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Maine, New Hampshire, in these survey areas: Coos County Area, New Hampshire; Somerset County, Maine, Southern Part.
By state: wild clay in Maine,wild clay in New Hampshire.
USDA, distribution and extent: MLRAs 143 and 146 in Maine and New Hampshire. The series is of moderate extent.
USDA, geographic setting: Madawaska soils are on outwash plains and stream terraces. Slope is dominantly 0 to 8 percent, but ranges up to 15 percent near the contact zone with upland till ridges. The soils formed in materials derived mainly from slate, schist, gneiss, phyllite, granite, and quartzite. The climate is humid and cool temperate. Mean annual precipitation ranges from 864 to to 1219 mm (34 to 48 in), and mean annual temperature ranges from about 3 to 7 degrees C (38 to 46 degrees F). The frost-free season ranges from 80 to 160 days. Elevation ranges from about 6 to 610 m (20 to 2000 ft) above mean sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Biddeford: Strong lead
- Buxton: Strong lead
- Lamoine: Strong lead
- Melrose: Strong lead
- Scantic: Strong lead
- Suffield: Strong lead
- Adams: Weak indication
- Berkshire: Weak indication
See it on the map
Open a Madawaska spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Madawaska very fine sandy loam, 0 to 3 percent slopes, map unit 28A in Coos County Area, New Hampshire.
- Official Series Description: Madawaska(revised 02/2017), established.
- Taxonomic class: Coarse-loamy over sandy or sandy-skeletal, isotic, frigid Aquic Haplorthods
- Rated with rule version 2026-09-28.1; the method is on the About page.