Longmarsh soil
Wild-clay potential
Weak indication
Weak indication: no layer of Longmarsh shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Longmarsh soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Longmarsh spot on the map
Rated from the USDA soil survey record for Longmarsh sandy loam (Harford County, Aberdeen Proving Ground, Maryland) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 4% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 32 in (82 cm)).
- Note Typically starts about 34 in (86 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential Noticeable rock fragments (about 23% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Sandy layerH1 A sandy loam layer about 0 to 19 in down: about 12% clay, low plasticity when wet, very dark gray when moist. Weak indication
- Sandy layerH2 A sandy loam layer about 19 to 34 in down: about 10% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerH3best layer A stratified coarse sand to gravelly loamy sand layer about 34 to 66 in down: about 4% clay, low plasticity when wet, light gray when moist. Weak indication
What it looks like raw
The sandy layer (H3), 34 to 66 in down in the typical profile: light gray (2.5Y 7/2); loose. Raw colour is not fired colour.
About the soil
- USDA family mineralogy: siliceous.
- USDA family particle-size class: coarse-loamy.
- Drainage: very poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Maryland, in these survey areas: Cecil County, Maryland; Harford County, Aberdeen Proving Ground, Maryland; Prince George's County, Maryland.
By state: wild clay in Maryland.
USDA, distribution and extent: Flood plains of the mid-Atlantic Coastal Plain of Maryland, Delaware, and New Jersey. This series is of small extent.
USDA, geographic setting: Longmarsh soils are nearly level soils on flood plains of the mid-Atlantic Coastal Plain. They formed in loamy alluvium overlying sandy and gravelly sediments. Mean annual temperature is 55 degrees F, and mean annual precipitation is 43 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Christiana: Strong lead
- Lenni: Strong lead
- Howell: Strong lead
- Magnolia: Strong lead
- Montalto: Strong lead
- Watchung: Strong lead
- Elkton: Promising
- Aquasco: Promising
See it on the map
Open a Longmarsh spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Longmarsh sandy loam, map unit Lo in Harford County, Aberdeen Proving Ground, Maryland.
- Official Series Description: Longmarsh(revised 11/2002), established.
- Taxonomic class: Coarse-loamy, siliceous, active, acid, mesic Fluvaquentic Humaquepts
- Rated with rule version 2026-09-28.1; the method is on the About page.