Linden soil
Wild-clay potential
Weak indication
Weak indication: no layer of Linden shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Linden soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Linden silt loam (Schuylkill County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 14% clay.
- Lowers the potential Low engineering plasticity index (1.5): little plastic behavior expected when wet.
- Note The official series description calls the wet soil nonsticky and slightly plastic.
- Note Thick enough to investigate (about 36 in (92 cm)).
- Note Typically starts within about 12 in (30 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 18% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilAp A silt loam layer about 0 to 12 in down: about 14% clay, moderate plasticity when wet, dark brown when moist. Weak indication
- Sandy layerBbest layer A gravelly silt loam layer about 12 to 48 in down: about 14% clay, low plasticity when wet, reddish brown when moist. Weak indication
- Sandy layerC A sandy loam layer about 48 to 70 in down: about 15% clay, low plasticity when wet, reddish brown when moist. Weak indication
What it looks like raw
The sandy layer (B), 12 to 48 in down in the typical profile: reddish brown (5YR 4/4); friable, nonsticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from sedimentary rock.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
- Lithic bedrock typically about 70 in (178 cm) down.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Pennsylvania, in these survey areas: Berks County, Pennsylvania; Lancaster County, Pennsylvania; Lehigh County, Pennsylvania; Schuylkill County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Pennsylvania, Maryland, and West Virginia. The series is of moderate extent.
USDA, geographic setting: Linden soils are on nearly level floodplains and are subject to stream overflow. Slopes range from 0 to 3 percent. They have formed in alluvial sediments washed from nearby uplands that are underlain by red and brown shales, sandstones, and in some areas, conglomerate. The climate is humid temperature. Mean annual precipitation ranges from 32 to 45 inches; mean annual air temperature ranges from 45 to 55 degrees F; and the frost-free season ranges from 120 to 180 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Hagerstown: Strong lead
- Watchung: Strong lead
- Bowmansville: Promising
- Duffield: Promising
- Holly: Promising
- Mount Lucas: Promising
- Readington: Promising
- Towhee: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Linden silt loam, map unit Ln in Schuylkill County, Pennsylvania.
- Official Series Description: Linden(revised 07/2001), established.
- Taxonomic class: Coarse-loamy, mixed, active, mesic Fluventic Dystrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.