Ligget soil
Wild-clay potential
Weak indication
Weak indication: no layer of Ligget shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Ligget soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Ligget sandy loam, 5 to 30 percent slopes (Adams-Washington Area, Parts of Adams and Washington Counties, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 8% clay.
- Lowers the potential Low engineering plasticity index (4): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 50 in (127 cm)).
- Note Typically starts within about 7 in (18 cm) of the surface.
- Note Few rock fragments (about 10% by volume).
Layer by layer
- Organic top layerOi An organic top layer about 0 to 3 in down, not a clay body. Weak indication
- TopsoilA A sandy loam layer about 3 to 7 in down: about 9% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layerBwbest layer A sandy loam layer about 7 to 57 in down: about 8% clay, low plasticity when wet, pale brown when moist. Weak indication
- BedrockCr Bedrock about 57 to 67 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (Bw), 7 to 57 in down in the typical profile: pale brown (10YR 6/3), brown (10YR 4/3) moist; slightly hard and very friable. Raw colour is not fired colour.
About the soil
- Parent material: volcanic ash and/or colluvium over residuum weathered from granite and/or quartzite.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
- Paralithic bedrock typically about 57 in (145 cm) down.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Idaho, in these survey areas: Adams-Washington Area, Parts of Adams and Washington Counties, Idaho; South Idaho Forests, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: West Central Idaho. It is inextensive.
USDA, geographic setting: The soils are in rolling to very steep, dissected hills and mountains. Slopes are mostly 40 to 55 percent but range from 5 to 60 percent. The elevations range from 4,000 feet, where aspects are northerly, to 7,000 feet or higher. The soils formed in deeply weathered dioritic or related materials. The mean annual precipitation is 25 to 32 inches, including 8 to 13 feet of snowfall. The average frost-free period ranges from 30 to 80 days. Average annual air temperature is 36 to 44 degrees F.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cabarton: Strong lead
- Sudpeak: Strong lead
- Blackwell: Promising
- Swede: Promising
- Catherine: Promising
- Culdecole: Promising
- Ticanot: Possible
- Brownlee: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Ligget sandy loam, 5 to 30 percent slopes, map unit 121 in Adams-Washington Area, Parts of Adams and Washington Counties, Idaho.
- Official Series Description: Ligget(revised 03/2008), established.
- Taxonomic class: Coarse-loamy, mixed, superactive Lamellic Haplocryepts
- Rated with rule version 2026-09-28.1; the method is on the About page.