Lehigh soil
Wild-clay potential
Weak indication
Weak indication: no layer of Lehigh shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Lehigh soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Lehigh silt loam, 0 to 8 percent slopes, very stony (Montgomery County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 25% clay. It may need settling or refining to become a clay body.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (17).
- Lowers the potential The official series description calls the wet soil slightly sticky and nonplastic.
- Note Thick enough to investigate (about 21 in (53 cm)).
- Note Typically starts within about 7 in (18 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 32% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilAp A silt loam layer about 0 to 7 in down: about 15% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Clay subsoilBtbest layer A channery silt loam layer about 7 to 28 in down: about 25% clay, moderate plasticity when wet, brown when moist. Weak indication
- Loamy layerC A very channery silt loam layer about 28 to 40 in down: about 25% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- BedrockR Bedrock about 40 to 44 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay subsoil (Bt), 7 to 28 in down in the typical profile: brown (10YR 4/3); friable, slightly sticky, nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from porcellanite.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: moderately well drained.
- Lithic bedrock typically about 40 in (102 cm) down.
Where it is mapped
Seen on the map as the most common soil in 20 map units in Pennsylvania, in these survey areas: Berks County, Pennsylvania; Bucks County, Pennsylvania; Chester County, Pennsylvania; Lancaster County, Pennsylvania; Lebanon County, Pennsylvania; Lehigh County, Pennsylvania; Montgomery County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Triassic basins of the Piedmont in Pennsylvania, New Jersey, and Maryland. The series is of moderate extent.
USDA, geographic setting: Lehigh soils are nearly level to moderately steep soils on hills and low ridges. The regolith is formed in residuum from porcelanite (metamorphosed shale and sandstone). The porcelanite areas commonly occur in bands separating areas of diabase and red Triassic sandstone and shale. Climate is continental with warm summers and cold winters. Mean annual rainfall ranges from 40 to 48 inches. Mean annual temperature ranges from 50 to 55 degrees F. The frost-free season ranges from about 165 to 200 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Watchung: Strong lead
- Hagerstown: Strong lead
- Bowmansville: Promising
- Mount Lucas: Promising
- Readington: Promising
- Duffield: Promising
- Rowland: Promising
- Towhee: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 95%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Lehigh silt loam, 0 to 8 percent slopes, very stony, map unit LsB in Montgomery County, Pennsylvania.
- Official Series Description: Lehigh(revised 02/2008), established.
- Taxonomic class: Fine-loamy, mixed, superactive, mesic Aquic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.