Lawrenceville soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 47 to 75 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Lawrenceville soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Lawrenceville spot on the map
Rated from the USDA soil survey record for Lawrenceville silt loam, 0 to 3 percent slopes (Montgomery County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 23% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (15).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 28 in (72 cm)).
- Note Typically starts about 47 in (119 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 14% by volume).
Layer by layer
- TopsoilAp A silt loam layer about 0 to 12 in down: about 18% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Clay subsoilBt A silt loam layer about 12 to 26 in down: about 25% clay, moderate plasticity when wet, dark yellowish brown when moist. Possible
- Loamy layerBx A silt loam layer about 26 to 47 in down: about 23% clay, moderate plasticity when wet, dark yellowish brown when moist. Possible
- Loamy layerCbest layer A silt loam layer about 47 to 75 in down: about 23% clay, moderate plasticity when wet, dark yellowish brown when moist. Possible
What it looks like raw
The loamy layer (C), 47 to 75 in down in the typical profile: dark yellowish brown (10YR 4/4); firm, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: loess over residuum weathered from shale and siltstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: moderately well drained.
- Lithic bedrock typically about 80 in (203 cm) down.
Where it is mapped
Seen on the map as the most common soil in 5 map units in Pennsylvania, in these survey areas: Bucks County, Pennsylvania; Chester County, Pennsylvania; Montgomery County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Southeastern Pennsylvania and central New Jersey. The series is of moderate extent.
USDA, geographic setting: These soils occur on nearly level to sloping uplands and terraces with an extreme slope range from 0 to 15 percent. The regolith consists largely of silty materials which mantle a wide range of consolidated and unconsolidated deposits. Climate is humid and temperate with mean annual temperature of 50 to 57 degrees F., mean annual precipitation of 40 to 46 inches, and a growing season of 140 to 200 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Watchung: Strong lead
- Bowmansville: Promising
- Croton: Promising
- Hatboro: Promising
- Mount Lucas: Promising
- Raritan: Promising
- Readington: Promising
- Rowland: Promising
See it on the map
Open a Lawrenceville spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 81%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Lawrenceville silt loam, 0 to 3 percent slopes, map unit LeA in Montgomery County, Pennsylvania.
- Official Series Description: Lawrenceville(revised 01/2006), established.
- Taxonomic class: Fine-silty, mixed, active, mesic Oxyaquic Fragiudalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.