Lamondi soil
Wild-clay potential
Weak indication
Weak indication: no layer of Lamondi shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Lamondi soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Lamondi spot on the map
Rated from the USDA soil survey record for Lamondi stony loam, 3 to 15 percent slopes (Morgan Area, Utah - Morgan County and Part of Weber County) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 23% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (7.5).
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 31 in (79 cm)).
- Note Typically starts within about 21 in (53 cm) of the surface.
- Lowers the potential High rock content (about 60% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- TopsoilA11 A gravelly loam layer about 0 to 3 in down: about 23% clay, moderate plasticity when wet, very dark brown when moist. Weak indication
- TopsoilA12 A cobbly loam layer about 3 to 10 in down: about 23% clay, moderate plasticity when wet, very dark brown when moist. Weak indication
- TopsoilA13 A very stony loam layer about 10 to 21 in down: about 23% clay, moderate plasticity when wet, very dark grayish brown when moist. Weak indication
- Loamy layerB21, B22best layer An extremely stony loam layer about 21 to 52 in down: about 23% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Loamy layerB3 An extremely gravelly loam layer about 52 to 60 in down: about 23% clay, moderate plasticity when wet, dark yellowish brown when moist. Weak indication
What it looks like raw
The loamy layer (B21, B22), 21 to 52 in down in the typical profile: yellowish brown (10YR 5/4), light yellowish brown (10YR 6/4) dry; hard, firm, sticky and plastic. Raw colour is not fired colour.
About the soil
- Parent material: slope alluvium and colluvium derived from argillite, phyllite, schist, and quartzite.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Utah, in these survey areas: Morgan Area, Utah - Morgan County and Part of Weber County.
By state: wild clay in Utah.
USDA, distribution and extent: Northern Utah. This series is inextensive.
USDA, geographic setting: Lamondi soils are at elevations of 5,100 to 7,000 feet. They occur on sloping to steep alluvial fans. Slopes range from 3 to 30 percent. These soils formed in alluvium weathered from argillite, phyllite, schist and quartzite. The climate is moist subhumid, and the average annual precipitation ranges from 18 to 25 inches. The mean annual temperature is 41 to 45 F. The mean summer temperature is 60 degrees to 65 degrees F., and the frost-free period ranges from 70 to 100 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Ant Flat: Strong lead
- Bertag: Strong lead
- Broadhead: Strong lead
- Crooked Creek: Strong lead
- Donner: Strong lead
- Hawkins: Strong lead
- Herd: Strong lead
- Isbell: Strong lead
See it on the map
Open a Lamondi spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Lamondi stony loam, 3 to 15 percent slopes, map unit LaD in Morgan Area, Utah - Morgan County and Part of Weber County.
- Official Series Description: Lamondi(revised 03/2003), established.
- Taxonomic class: Loamy-skeletal, mixed, superactive, frigid Pachic Ultic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.