Kimberly soil
Wild-clay potential
Weak indication
Weak indication: no layer of Kimberly shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Kimberly soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Kimberly spot on the map
Rated from the USDA soil survey record for Kimberly-Beetville complex. 0 to 2 percent slopes (Ada County, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 2% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 17 in (43 cm)).
- Note Typically starts about 43 in (109 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 50% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- TopsoilAp A fine sandy loam layer about 0 to 8 in down: about 15% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- TopsoilA2 A fine sandy loam layer about 8 to 18 in down: about 17% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerBk1 A fine sandy loam layer about 18 to 28 in down: about 17% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Loamy layerBk2 A fine sandy loam layer about 28 to 41 in down: about 18% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- TopsoilAb A fine sandy loam layer about 41 to 43 in down: about 13% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layer2Cbest layer A very gravelly sand layer about 43 to 60 in down: about 2% clay, low plasticity when wet, grayish brown when moist. Weak indication
What it looks like raw
The sandy layer (2C), 43 to 60 in down in the typical profile: grayish brown (10YR 5/2), very dark grayish brown (10YR 3/2) moist; loose, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: coarse-loamy alluvium over sandy and gravelly alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Idaho, in these survey areas: Ada County, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Kimberly soils are along major drainages of eastern Oregon; MLRA 10 and 11. The series is of moderate extent.
USDA, geographic setting: Kimberly soils are on floodplains at elevations of 400 to 2,500 feet. Slope gradients are 0 to 3 percent. The soils formed in recent mixed moderately coarse textured alluvium. The climate is semiarid with hot dry summers and cold moist winters. The mean annual precipitation ranges from 8 to 14 inches. The mean annual temperature is 45 to 53 degrees F. The mean January temperature is about 32 degrees F., and the mean July temperature is about 68 degrees F. The frost-free period is about 100 to 180 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aldape: Strong lead
- Aradaran: Strong lead
- Bowns: Strong lead
- Breadloaf: Strong lead
- Brent: Strong lead
- Castlerock: Strong lead
- Catchell: Strong lead
- Chardoton: Strong lead
See it on the map
Open a Kimberly spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 65%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Kimberly-Beetville complex. 0 to 2 percent slopes, map unit 1011 in Ada County, Idaho.
- Official Series Description: Kimberly(revised 02/2006), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, mesic Torrifluventic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.