Kilfoil soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 3 to 21 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Kilfoil soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Kilfoil spot on the map
Rated from the USDA soil survey record for Kilfoil-Rock outcrop complex, 40 to 60 percent slopes (Morgan Area, Utah - Morgan County and Part of Weber County) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 31% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (12.5).
- Note The official series description calls the wet soil moderately sticky and slightly plastic.
- Note Thick enough to investigate (about 18 in (45 cm)).
- Note Typically starts within about 3 in (8 cm) of the surface.
- Note Few rock fragments (about 14% by volume).
- Note USDA reports about 6% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilA11, A12 A loam layer about 0 to 3 in down: about 23% clay, moderate plasticity when wet, dark brown when moist. Weak indication
- Loamy layerB21t, B22tbest layer A clay loam layer about 3 to 21 in down: about 31% clay, moderate plasticity when wet, dark brown when moist. Promising
- Loamy layerCk A very gravelly loam layer about 21 to 30 in down: about 23% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- BedrockCr Weathered bedrock about 30 to 34 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (B21t, B22t), 3 to 21 in down in the typical profile: dark brown (10YR 4/3), light yellowish brown (10YR 6/4) dry; hard, firm, sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium over residuum derived from sandstone and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
- Paralithic bedrock typically about 30 in (76 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Utah, in these survey areas: Morgan Area, Utah - Morgan County and Part of Weber County.
By state: wild clay in Utah.
USDA, distribution and extent: These soils occur in northern Utah. This series is inextensive.
USDA, geographic setting: Kilfoil soils are at elevations of 5,500 to 7,700 feet. They occur on south-facing even or convex mountain slopes. Slopes ranges from 25 to 60 percent. these soils formed in residuum and local alluvium weathered from sandstone and shale. The climate is moist subhumid, and the average annual precipitation ranges from 18 to 25 inches. The mean annual temperature is 39 to 41 degrees F. The mean summer temperature is 59 to 61 degrees F., and the frost-free period ranges from 70 to 80 days. ASSOCIATED SOILS: These are the Croydon, Hades, Isbell, Moweba and St. Marys soils. All of these soils are more- than 40 inches deep to bedrock. Croydon soils have mean summer temperatures less than 59...
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Ant Flat: Strong lead
- Bertag: Strong lead
- Broadhead: Strong lead
- Crooked Creek: Strong lead
- Donner: Strong lead
- Hawkins: Strong lead
- Herd: Strong lead
- Isbell: Strong lead
See it on the map
Open a Kilfoil spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 65%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Kilfoil-Rock outcrop complex, 40 to 60 percent slopes, map unit KrG in Morgan Area, Utah - Morgan County and Part of Weber County.
- Official Series Description: Kilfoil(revised 03/2003), established.
- Taxonomic class: Fine-loamy, mixed, superactive, frigid Mollic Haploxeralfs
- Rated with rule version 2026-09-28.1; the method is on the About page.