Kilburn soil
Wild-clay potential
Weak indication
Weak indication: no layer of Kilburn shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Kilburn soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Kilburn spot on the map
Rated from the USDA soil survey record for Kilburn gravelly sandy loam, 3 to 6 percent slopes (Box Elder County, Utah, Eastern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 7% clay.
- Lowers the potential Low engineering plasticity index (5): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 25 in (63 cm)).
- Note Typically starts about 35 in (89 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 53% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
- Note USDA reports about 8% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilA11 A gravelly sandy loam layer about 0 to 8 in down: about 14% clay, low plasticity when wet, very dark grayish brown when moist. Weak indication
- TopsoilA12 A gravelly sandy loam layer about 8 to 14 in down: about 14% clay, low plasticity when wet, very dark grayish brown when moist. Weak indication
- Sandy layerB2 A gravelly loam layer about 14 to 22 in down: about 14% clay, low plasticity when wet, light olive brown when moist. Weak indication
- Sandy layerC1 A very gravelly sandy loam layer about 22 to 35 in down: about 7% clay, low plasticity when wet, light olive brown when moist. Weak indication
- Sandy layerC2best layer A very gravelly loamy sand layer about 35 to 60 in down: about 7% clay, low plasticity when wet, light olive brown when moist. Weak indication
What it looks like raw
The sandy layer (C2), 35 to 60 in down in the typical profile: light olive brown (2.5Y 5/4). Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from quartzite, gneiss, and schist.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: somewhat excessively drained.
Where it is mapped
Seen on the map as the most common soil in 23 map units in Utah, in these survey areas: Box Elder County, Utah, Eastern Part; Davis-Weber Area, Utah; Tooele Area, Utah - Tooele County and Parts of Box Elder, Davis and Juab Counties.
By state: wild clay in Utah.
USDA, distribution and extent: Central and northern Utah along the Wasatch Front. The soil is of large extent.
USDA, geographic setting: The Kilburn soils are on nearly level to very steep, colluvial and alluvial fans, fan terraces, high lake terraces, stream terraces and deltas. Elevations ranges from 4,400 to 5,300 feet. Slopes are dominantly 0 to 20 percent but range from 0 to 50 percent. These soils formed in alluvium and colluvium derived mainly from gneiss, granite, sandstone, and schist, and also includes material from other kinds of rocks. The climate is dry subhumid. The mean annual temperature is 45 to 52 degrees F; the mean summer temperature is 68 to 73 degrees F, and the freeze-free period is 140 to 180 days. The mean annual precipitation ranges from 15 to 19 inches and 12 to 16 inches fall during the period...
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Eimarsh: Strong lead
- Payson: Strong lead
- Pintailake: Strong lead
- Saltair: Strong lead
- Woods Cross: Strong lead
- Abbott: Strong lead
- Airport: Strong lead
- Collett: Strong lead
See it on the map
Open a Kilburn spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 95%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Kilburn gravelly sandy loam, 3 to 6 percent slopes, map unit KnC in Box Elder County, Utah, Eastern Part.
- Official Series Description: Kilburn(revised 03/2003), established.
- Taxonomic class: Loamy-skeletal, mixed, superactive, mesic Typic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.