Kidman soil
Wild-clay potential
Weak indication
Weak indication: no layer of Kidman shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Kidman soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Kidman fine sandy loam, 0 to 2 percent slopes (Box Elder County, Utah, Eastern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 14% clay.
- Lowers the potential Low engineering plasticity index (5): little plastic behavior expected when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 15 in (38 cm)).
- Note Typically starts within about 14 in (36 cm) of the surface.
- Missing data Rock fragment content is not reported.
Layer by layer
- Sandy layerH1 A fine sandy loam layer about 0 to 6 in down: about 13% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerH2 A fine sandy loam layer about 6 to 14 in down: about 13% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerH3best layer A fine sandy loam layer about 14 to 29 in down: about 14% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layerH4 A fine sandy loam layer about 29 to 41 in down: about 13% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
- Sandy layerH5 A fine sandy loam layer about 41 to 50 in down: about 13% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
- Sandy layerH6 A fine sandy loam layer about 50 to 60 in down: about 13% clay, low plasticity when wet, very pale brown when moist. Weak indication
What it looks like raw
The sandy layer (H3), 14 to 29 in down in the typical profile: yellowish brown (10YR 5/4), brown (7.5YR 4/3) moist; slightly hard, friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium and lacustrine deposits derived from limestone, quartzite, and sandstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 7 map units in Utah, in these survey areas: Box Elder County, Utah, Eastern Part; Davis-Weber Area, Utah.
By state: wild clay in Utah.
USDA, distribution and extent: Central and northern Utah and southeastern Idaho. These soils are moderately extensive. MLRA 28A.
USDA, geographic setting: Kidman soils are on alluvial fans, fan remnants, stream terraces, lake plains, or lake terraces. Slopes of less than 1 percent are most common but slopes range from 0 to 40 percent. Elevations range from 4,000 to 6,500 feet. These soils formed in alluvium or lacustrine deposits that have been extensively modified by wind and are derived mainly from quartzite, sandstone, granite, limestone, and gneiss. The climate is dry subhumid. The mean annual precipitation is 12 to 19 inches. The mean annual temperature is 45 to 53 degrees F. and the mean summer temperature is 68 to 73 degrees F. The frost-free period is 100 to 175 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Eimarsh: Strong lead
- Payson: Strong lead
- Pintailake: Strong lead
- Saltair: Strong lead
- Woods Cross: Strong lead
- Abbott: Strong lead
- Airport: Strong lead
- Collett: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Kidman fine sandy loam, 0 to 2 percent slopes, map unit KlA in Box Elder County, Utah, Eastern Part.
- Official Series Description: Kidman(revised 10/2005), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, mesic Calcic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.