Jugson soil
Wild-clay potential
Weak indication
Weak indication: no layer of Jugson shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Jugson soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Jugson coarse sandy loam, 5 to 30 percent slopes (Valley Area, Idaho, Parts of Adams and Valley Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 10% clay.
- Lowers the potential Low engineering plasticity index (6): little plastic behavior expected when wet.
- Note The official series description calls the wet soil slightly sticky.
- Note Thick enough to investigate (about 20 in (50 cm)).
- Note Typically starts within about 2 in (6 cm) of the surface.
- Note Few rock fragments (about 8% by volume).
Layer by layer
- Organic top layerOi An organic top layer about 0 to 1 in down, not a clay body. Weak indication
- Organic top layerOe An organic top layer about 1 to 2 in down, not a clay body. Weak indication
- Sandy layerE A coarse sandy loam layer about 2 to 2 in down: about 10% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layerBwbest layer A coarse sandy loam layer about 2 to 22 in down: about 10% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerC A loamy coarse sand layer about 22 to 37 in down: about 4% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- BedrockCr Bedrock about 37 to 41 in down: no clay layer to dig. Weak indication
- BedrockR Bedrock about 41 to 51 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (Bw), 2 to 22 in down in the typical profile: grayish brown (10YR 5/2), dark brown (10YR 3/3) moist; soft, very friable, slightly sticky. Raw colour is not fired colour.
About the soil
- Parent material: alluvium and/or colluvium over residuum over bedrock derived from granite.
- USDA family particle-size class: sandy.
- Drainage: somewhat excessively drained.
- Lithic bedrock typically about 41 in (104 cm) down.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Idaho, in these survey areas: South Idaho Forests, Idaho; Valley Area, Idaho, Parts of Adams and Valley Counties.
By state: wild clay in Idaho.
USDA, distribution and extent: Widely distributed in the colder areas of the Idaho batholith of north-central Idaho. The series is extensive.
USDA, geographic setting: Jugson soils are on mountainous slopes, usually with a northerly aspect. Slopes are 5 to 70 percent. They formed in residuum from granite, quartz, monzonite, gneiss or similar coarse-grained acid igneous bedrock. Elevations are 3,300 to 7,000 feet. Mean annual precipitation is 25 to 45 inches. Mean annual temperature is 29 degrees to 39 degrees F. Frost-free season is 10 to 70 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cabarton: Strong lead
- Blackwell: Promising
- Swede: Promising
- Catherine: Promising
- Nisula: Promising
- Archabal: Possible
- Brownlee: Possible
- Tica: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 75%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Jugson coarse sandy loam, 5 to 30 percent slopes, map unit 25 in Valley Area, Idaho, Parts of Adams and Valley Counties.
- Official Series Description: Jugson(revised 03/2008), established.
- Taxonomic class: Sandy, isotic Vitrandic Haplocryepts
- Rated with rule version 2026-09-28.1; the method is on the About page.