James Canyon soil
Wild-clay potential
Possible
Possible: a surface layer with some clay typically about 15 to 35 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about James Canyon soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a James Canyon spot on the map
Rated from the USDA soil survey record for James Canyon loam, 0 to 3 percent slopes (Box Elder County, Utah, Eastern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 23% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (7.5).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 20 in (51 cm)).
- Note Typically starts within about 15 in (38 cm) of the surface.
- Note Few rock fragments (about 13% by volume).
- Note Surface layer; expect roots and organic matter.
Layer by layer
- TopsoilAp A loam layer about 0 to 8 in down: about 23% clay, moderate plasticity when wet, dark gray when moist. Possible
- TopsoilA11 A loam layer about 8 to 15 in down: about 23% clay, moderate plasticity when wet, dark gray when moist. Possible
- TopsoilA12best layer A loam layer about 15 to 35 in down: about 23% clay, moderate plasticity when wet, dark gray when moist. Possible
- Loamy layerC1 A gravelly loam layer about 35 to 40 in down: about 23% clay, moderate plasticity when wet, light olive gray when moist. Weak indication
- Sandy layerC2 A very gravelly sandy loam layer about 40 to 60 in down: about 18% clay, low plasticity when wet, gray when moist. Weak indication
What it looks like raw
The topsoil (A12), 15 to 35 in down in the typical profile: dark gray (10YR 4/1), black (10YR 2/1) moist; slightly hard, very friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from quartzite and/or alluvium derived from sandstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Utah, in these survey areas: Box Elder County, Utah, Eastern Part.
By state: wild clay in Utah.
USDA, distribution and extent: Northern Nevada, western Utah, and northeastern California. These soils are moderately extensive. MLRAs 21, 26, 28A, and 28B.
USDA, geographic setting: James Canyon soils are on flood plains and alluvial fans. These soils formed in alluvium derived from mixed rocks. Slopes are O to 8 percent. Elevations range from 1,280 to 1,830 meters. The climate is semiarid with cool, moist winters and warm, dry summers. The mean annual precipitation is 200 to 410 mm, mean annual temperature is 7 to 10 degrees C, and the frost-free period is 90 to 160 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Collett: Strong lead
- Eimarsh: Strong lead
- Goring: Strong lead
- Lasil: Strong lead
- Manila: Strong lead
- Obray: Strong lead
- Payson: Strong lead
- Pintailake: Strong lead
See it on the map
Open a James Canyon spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for James Canyon loam, 0 to 3 percent slopes, map unit JaA in Box Elder County, Utah, Eastern Part.
- Official Series Description: James Canyon(revised 11/2016), established.
- Taxonomic class: Fine-loamy, mixed, superactive, mesic Cumulic Endoaquolls
- Rated with rule version 2026-09-28.1; the method is on the About page.