Ironton soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 36 to 48 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Ironton soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Ironton spot on the map
Rated from the USDA soil survey record for Ironton-Draper complex, 0 to 3 percent slopes (Davis-Weber Area, Utah) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 19% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (12).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 12 in (31 cm)).
- Note Typically starts about 36 in (91 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
- Note USDA reports about 36% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilA11 A silt loam layer about 0 to 6 in down: about 19% clay, moderate plasticity when wet, gray when moist. Weak indication
- TopsoilA12 A silt loam layer about 6 to 16 in down: about 17% clay, moderate plasticity when wet, gray when moist. Weak indication
- TopsoilA13ca A loam layer about 16 to 21 in down: about 19% clay, moderate plasticity when wet, gray when moist. Weak indication
- Sandy layerC1ca A loam layer about 21 to 36 in down: about 13% clay, moderate plasticity when wet, light gray when moist. Weak indication
- Loamy layerC2cabest layer A silt loam layer about 36 to 48 in down: about 19% clay, moderate plasticity when wet, light gray when moist. Possible
- Loamy layerC3 A silt loam layer about 48 to 60 in down: about 26% clay, moderate plasticity when wet, light gray when moist. Weak indication
What it looks like raw
The loamy layer (C2ca), 36 to 48 in down in the typical profile: light gray (2.5Y 7/2), grayish brown (2.5Y 5/2) moist; very hard, firm, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium and/or lacustrine deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 5 map units in Utah, in these survey areas: Davis-Weber Area, Utah.
By state: wild clay in Utah.
USDA, distribution and extent: Northcentral Utah. These soils are not extensive with about 5,300 acres of the series mapped to date. MLRA 28A.
USDA, geographic setting: Ironton soils are on low lake terraces and flood plains. These soils formed in alluvium and lacustrine deposits derived from mixed rocks that are dominantly quartzite, gneiss, and limestone. Slopes are 0 to 6 percent. Elevations range from 4,200 to 4,750 feet. The climate is dry subhumid. The mean annual precipitation is 14 to 18 inches. The mean annual temperature is 47 to 52 degrees F., and the frost-free period is 130 to 170 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Abbott: Strong lead
- Airport: Strong lead
- Eimarsh: Strong lead
- Kirkham: Strong lead
- Payson: Strong lead
- Pintailake: Strong lead
- Saltair: Strong lead
- Woods Cross: Strong lead
See it on the map
Open a Ironton spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 60%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Ironton-Draper complex, 0 to 3 percent slopes, map unit IDA in Davis-Weber Area, Utah.
- Official Series Description: Ironton(revised 03/2006), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, mesic Oxyaquic Calcixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.