Hoypus soil
Wild-clay potential
Weak indication
Weak indication: no layer of Hoypus shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Hoypus soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Hoypus gravelly loamy sand, 0 to 15 percent slopes (Jefferson County Area, Washington) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 2% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 34 in (86 cm)).
- Note Typically starts about 26 in (66 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 41% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A gravelly loamy sand layer about 0 to 2 in down: about 4% clay, low plasticity when wet, very dark brown when moist. Weak indication
- Sandy layerH2 A gravelly loamy sand layer about 2 to 10 in down: about 8% clay, low plasticity when wet, dark yellowish brown when moist. Weak indication
- Sandy layerH3 A gravelly loamy sand layer about 10 to 26 in down: about 2% clay, low plasticity when wet, dark yellowish brown when moist. Weak indication
- Sandy layerH4best layer A gravelly loamy sand layer about 26 to 60 in down: about 2% clay, low plasticity when wet, dark brown when moist. Weak indication
What it looks like raw
The sandy layer (H4), 26 to 60 in down in the typical profile: loose, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: glacial outwash.
- USDA family mineralogy: mixed.
- USDA family particle-size class: sandy-skeletal.
- Drainage: somewhat excessively drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Washington, in these survey areas: Jefferson County Area, Washington.
By state: wild clay in Washington.
USDA, distribution and extent: Northwestern Washington. Series is moderately extensive.
USDA, geographic setting: Hoypus soils are on hillslopes and glacial outwash plains at elevations of 0 to 1,000 feet. Slopes are 3 to 50 percent. These soils formed in glacial outwash. The climate is characterized by cool, dry summers and cool, moist winters. Average annual precipitation is 18 to 30 inches. Average January temperature is 38 degrees F., average July temperature is 60 degrees F., and the average annual temperature is 49 degrees F. The frost-free season is 200 to 240 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Quilcene: Strong lead
- Wapato: Promising
- Kitsap: Possible
- Lummi: Possible
- Ahl: Weak indication
- Alderwood: Weak indication
- Beausite: Weak indication
- Belfast: Weak indication
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Hoypus gravelly loamy sand, 0 to 15 percent slopes, map unit HuC in Jefferson County Area, Washington.
- Official Series Description: Hoypus(revised 02/2005), established.
- Taxonomic class: Sandy-skeletal, isotic, mesic Typic Xerorthents
- Rated with rule version 2026-09-28.1; the method is on the About page.