Hoskin soil
Wild-clay potential
Weak indication
Weak indication: no layer of Hoskin shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Hoskin soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Hoskin cobbly loam, 30 to 50 percent slopes (Morgan Area, Utah - Morgan County and Part of Weber County) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 31% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (12.5).
- Note The official series description calls the wet soil nonsticky and slightly plastic.
- Note Thick enough to investigate (about 20 in (51 cm)).
- Note Typically starts within about 19 in (48 cm) of the surface.
- Lowers the potential High rock content (about 50% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- TopsoilA11, A12 A very cobbly loam layer about 0 to 19 in down: about 23% clay, moderate plasticity when wet, brown when moist. Weak indication
- Loamy layerB21t, B22tbest layer A very cobbly clay loam layer about 19 to 39 in down: about 31% clay, moderate plasticity when wet, brown when moist. Weak indication
- BedrockR Unweathered bedrock about 39 to 43 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (B21t, B22t), 19 to 39 in down in the typical profile: brown (7.5YR 5/4), dark brown (7.5YR 4/4) moist; soft, friable, nonsticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium over residuum derived from conglomerate.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
- Lithic bedrock typically about 39 in (99 cm) down.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Utah, in these survey areas: Morgan Area, Utah - Morgan County and Part of Weber County.
By state: wild clay in Utah.
USDA, distribution and extent: Mountain areas in northern Utah. This series is moderately extensive.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Ant Flat: Strong lead
- Bertag: Strong lead
- Broadhead: Strong lead
- Crooked Creek: Strong lead
- Donner: Strong lead
- Hawkins: Strong lead
- Herd: Strong lead
- Isbell: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Hoskin cobbly loam, 30 to 50 percent slopes, map unit HwG in Morgan Area, Utah - Morgan County and Part of Weber County.
- Official Series Description: Hoskin(revised 03/2003), established.
- Taxonomic class: Loamy-skeletal, mixed, superactive, frigid Typic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.