Hartleton soil
Wild-clay potential
Weak indication
Weak indication: no layer of Hartleton shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Hartleton soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Hartleton spot on the map
Rated from the USDA soil survey record for Hartleton channery silt loam, 0 to 3 percent slopes (Carbon County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 21% clay. It may need settling or refining to become a clay body.
- Lowers the potential Low engineering plasticity index (3.5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 26 in (66 cm)).
- Note Typically starts about 32 in (81 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 56% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A channery silt loam layer about 0 to 8 in down: about 18% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Loamy layerH2 A very channery loam layer about 8 to 32 in down: about 23% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Loamy layerH3best layer A very channery loam layer about 32 to 58 in down: about 21% clay, low plasticity when wet, brown when moist. Weak indication
- BedrockR Weathered bedrock about 58 to 76 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (H3), 32 to 58 in down in the typical profile: brown (7.5YR 5/4); friable, nonsticky, nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from sandstone and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
- Lithic bedrock typically about 58 in (147 cm) down.
Where it is mapped
Seen on the map as the most common soil in 11 map units in Pennsylvania, in these survey areas: Carbon County, Pennsylvania; Schuylkill County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Distribution: New York, Pennsylvania, Virginia
USDA, geographic setting: Landscape: Mountains, hills, plateaus.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Shelmadine: Promising
- Comly: Promising
- Holly: Promising
- Kedron: Promising
- Allenwood: Possible
- Alvira: Possible
- Meckesville: Possible
- Watson: Possible
See it on the map
Open a Hartleton spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Hartleton channery silt loam, 0 to 3 percent slopes, map unit HaA in Carbon County, Pennsylvania.
- Official Series Description: Hartleton(revised 01/2017), established.
- Taxonomic class: Loamy-skeletal, mixed, active, mesic Typic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.