Hansel soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 33 to 62 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Hansel soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Hansel silt loam, 1 to 6 percent slopes (Box Elder County, Utah, Eastern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 30% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (15).
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 29 in (73 cm)).
- Note Typically starts about 33 in (84 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
- Note USDA reports about 23% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilA11 A silt loam layer about 0 to 6 in down: about 20% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
- TopsoilA12 A silt loam layer about 6 to 10 in down: about 20% clay, moderate plasticity when wet, light brownish gray when moist. Weak indication
- Loamy layerB21t A silty clay loam layer about 10 to 14 in down: about 30% clay, moderate plasticity when wet, light gray when moist. Possible
- Loamy layerB22t A silty clay loam layer about 14 to 18 in down: about 30% clay, moderate plasticity when wet, light gray when moist. Possible
- Loamy layerC1ca&2ca A silty clay loam layer about 18 to 33 in down: about 30% clay, moderate plasticity when wet, white when moist. Promising
- Loamy layerC3&C4best layer A silty clay loam layer about 33 to 62 in down: about 30% clay, moderate plasticity when wet, light gray when moist. Promising
What it looks like raw
The loamy layer (C3&C4), 33 to 62 in down in the typical profile: light gray (2.5Y 7/2), brown (10YR 5/3) moist; hard, firm, sticky and plastic. Raw colour is not fired colour.
About the soil
- Parent material: Lacustrine deposits derived from limestone, sandstone, and quartzite.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Utah, in these survey areas: Box Elder County, Utah, Eastern Part.
By state: wild clay in Utah.
USDA, distribution and extent: Northern and Central Utah. Moderately extensive. MLRA 28A.
USDA, geographic setting: Hansel soils occur on dissected intermediate lake terraces at elevations of 4,400 to 5,000 feet. Slopes range from 0 to 10 percent. The soils formed in lacustrine deposits derived from a variety of rocks. The climate is dry subhumid. The average annual precipitation ranges from 12 to 14 inches. The frost-free period ranges from 90 to 130 days. The mean annual temperature ranges from 46 to 49 degrees F.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Collett: Strong lead
- Eimarsh: Strong lead
- Goring: Strong lead
- Lasil: Strong lead
- Manila: Strong lead
- Obray: Strong lead
- Payson: Strong lead
- Pintailake: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Hansel silt loam, 1 to 6 percent slopes, map unit HaB in Box Elder County, Utah, Eastern Part.
- Official Series Description: Hansel(revised 03/2003), established.
- Taxonomic class: Fine-silty, mixed, superactive, mesic Calcic Haploxeralfs
- Rated with rule version 2026-09-28.1; the method is on the About page.