Hamplain soil
Wild-clay potential
Weak indication
Weak indication: no layer of Hamplain shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Hamplain soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Hamplain spot on the map
Rated from the USDA soil survey record for Hamplain silt loam (Otsego County, New York) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 5% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 40 in (101 cm)).
- Note Typically starts about 38 in (97 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 0% by volume).
Layer by layer
- Sandy layerH1 A silt loam layer about 0 to 9 in down: about 12% clay, moderate plasticity when wet, very dark grayish brown when moist. Weak indication
- Sandy layerH2 A silt loam layer about 9 to 38 in down: about 12% clay, moderate plasticity when wet, brown when moist. Weak indication
- Sandy layerH3best layer A loamy very fine sand layer about 38 to 78 in down: about 5% clay, low plasticity when wet, brown when moist. Weak indication
What it looks like raw
The sandy layer (H3), 38 to 78 in down in the typical profile: brown (10YR 4/3), and dark yellowish brown (10YR 4/4); loose. Raw colour is not fired colour.
About the soil
- Parent material: silty alluvium derived mainly from regolith containing sandstone, siltstone, and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-silty.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in New York, in these survey areas: Otsego County, New York.
By state: wild clay in New York.
USDA, distribution and extent: Central and Southern New York. The series is moderately extensive.
USDA, geographic setting: Hamplain soils are on floodplains near glacial till plateaus and glacial outwash terraces. Slopes range from 0 to 3 percent. The soils developed in post-glacial alluvium derived mainly from regolith containing sandstone, siltstone, and shale. Mean annual air temperature ranges from 46 to 50 degrees F, mean annual precipitation ranges from 35 to 45 inches, and mean annual frost-free days ranges from 105 to 170 days. Elevation ranges from 700 to 1400 feet above sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Alden: Possible
- Canandaigua: Possible
- Bath: Weak indication
- Castile: Weak indication
- Chenango: Weak indication
- Chippewa: Weak indication
- Hawksnest: Weak indication
- Lewbath: Weak indication
See it on the map
Open a Hamplain spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 75%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Hamplain silt loam, map unit Hb in Otsego County, New York.
- Official Series Description: Hamplain(revised 02/2000), established.
- Taxonomic class: Coarse-silty, mixed, active, mesic Fluventic Dystrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.