Castile soil
Wild-clay potential
Weak indication
Weak indication: no layer of Castile shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Castile soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Castile spot on the map
Rated from the USDA soil survey record for Castile channery silt loam, 3 to 8 percent slopes (Otsego County, New York) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 10% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 48 in (122 cm)).
- Note Typically starts about 24 in (61 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 65% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A channery silt loam layer about 0 to 9 in down: about 12% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerH2 A very gravelly loam layer about 9 to 24 in down: about 12% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerH3best layer An extremely gravelly sandy loam layer about 24 to 72 in down: about 10% clay, low plasticity when wet, grayish brown when moist. Weak indication
What it looks like raw
The sandy layer (H3), 24 to 72 in down in the typical profile: grayish brown (10YR 5/2); loose. Raw colour is not fired colour.
About the soil
- Parent material: gravelly loamy glaciofluvial deposits over sandy and gravelly glaciofluvial deposits, derived mainly from sandstone, shale, and siltstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in New York, in these survey areas: Otsego County, New York.
By state: wild clay in New York.
USDA, distribution and extent: Western, central and southern New York, and possibly northern Pennsylvania. MLRA 101, 139, 140, and 144A. The series is of small extent.
USDA, geographic setting: Castile soils are nearly level to undulating soils on glacial outwash plains, valley trains and associated kames, eskers and water-deposited parts of moraines. Slope ranges from 0 through 15 percent. The soils formed in water-sorted gravelly and sandy material high in gray sandstone, shale and siltstone with lesser amounts of limestone and igneous erratics. Mean annual precipitation ranges from 30 through 45 inches; mean annual air temperature ranges from 45 through 50 degrees F.; and the mean annual frost-free season ranges from 120 through 180 days. Elevation ranges from 500 through 1600 feet above sea-level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Alden: Possible
- Canandaigua: Possible
- Bath: Weak indication
- Chenango: Weak indication
- Chippewa: Weak indication
- Hamplain: Weak indication
- Hawksnest: Weak indication
- Lewbath: Weak indication
See it on the map
Open a Castile spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Castile channery silt loam, 3 to 8 percent slopes, map unit CfB in Otsego County, New York.
- Official Series Description: Castile(revised 12/2008), established.
- Taxonomic class: Loamy-skeletal, mixed, active, mesic Aquic Dystrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.