Hamilton soil
Wild-clay potential
Weak indication
Weak indication: no layer of Hamilton shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Hamilton soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Hamilton spot on the map
Rated from the USDA soil survey record for Hamilton silt loam, 0 to 4 percent slopes (Missoula County Area, Montana) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 14% clay.
- Note Moderate engineering plasticity index (9).
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 22 in (55 cm)).
- Note Typically starts about 32 in (82 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 2% by volume).
- Note USDA reports about 10% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilA A silt loam layer about 0 to 10 in down: about 21% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerBw A silt loam layer about 10 to 19 in down: about 16% clay, moderate plasticity when wet, pale brown when moist. Weak indication
- Sandy layerBk1 A silt loam layer about 19 to 32 in down: about 16% clay, moderate plasticity when wet, pale brown when moist. Weak indication
- Sandy layerBk2best layer A silt loam layer about 32 to 54 in down: about 14% clay, moderate plasticity when wet, light yellowish brown when moist. Weak indication
- Sandy layer2C A gravelly loamy fine sand layer about 54 to 60 in down: about 4% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
What it looks like raw
The sandy layer (Bk2), 32 to 54 in down in the typical profile: light yellowish brown (10YR 6/4), brown (10YR 5/3) moist; soft, very friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-silty.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Montana, in these survey areas: Missoula County Area, Montana.
By state: wild clay in Montana.
USDA, distribution and extent: Hamilton soils are of small extent in the intermountain valleys of southwest Montana. MLRA 44A.
USDA, geographic setting: Landform - stream terraces
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Crow: Strong lead
- Grassvalley: Strong lead
- Half Moon: Promising
- Bignell: Possible
- Burnt Fork: Possible
- Greenough: Possible
- Minesinger: Possible
- Alberton: Weak indication
See it on the map
Open a Hamilton spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Hamilton silt loam, 0 to 4 percent slopes, map unit 130B in Missoula County Area, Montana.
- Official Series Description: Hamilton(revised 05/2012), established.
- Taxonomic class: Coarse-silty, mixed, superactive, frigid Aridic Haplustolls
- Rated with rule version 2026-09-28.1; the method is on the About page.