Gwin soil
Wild-clay potential
Weak indication
Weak indication: no layer of Gwin shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Gwin soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Gwin-Linville complex, 30 to 65 percent slopes (Whitman County, Washington) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 26% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (15).
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Moderate thickness (about 11 in (28 cm)).
- Note Typically starts within about 7 in (18 cm) of the surface.
- Lowers the potential High rock content (about 46% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A cobbly silt loam layer about 0 to 7 in down: about 9% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Loamy layerH2best layer A very gravelly silt loam layer about 7 to 18 in down: about 26% clay, moderate plasticity when wet, brown when moist. Weak indication
- BedrockH3 Unweathered bedrock about 18 to 22 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (H2), 7 to 18 in down in the typical profile: brown (7.5YR 4/2) dry, dark brown (7.5YR 3/2) moist; hard, firm, moderately sticky and moderately plastic. Raw colour is not fired colour.
About the soil
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
- Lithic bedrock typically about 18 in (46 cm) down.
Where it is mapped
Seen on the map as the most common soil in 5 map units in Idaho, Washington, in these survey areas: Ada County, Idaho; Garfield County Area, Washington; Lewis and Nez Perce Counties, Idaho; Whitman County, Washington.
By state: wild clay in Idaho,wild clay in Washington.
USDA, distribution and extent: Eastern and central Washington, eastern Oregon, and western Idaho; MLRAs 8, 9, and 10; large extent
USDA, geographic setting: Elevation--490 to 1375 cm in Washington, 240 to 1900 cm in Oregon and Idaho; highest elevations on south aspects only
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aldape: Strong lead
- Aradaran: Strong lead
- Bowns: Strong lead
- Breadloaf: Strong lead
- Brent: Strong lead
- Castlerock: Strong lead
- Catchell: Strong lead
- Chardoton: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 60%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Gwin-Linville complex, 30 to 65 percent slopes, map unit 39 in Whitman County, Washington.
- Official Series Description: Gwin(revised 09/2019), established.
- Taxonomic class: Loamy-skeletal, mixed, superactive, mesic Lithic Argixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.