Galloway soil
Wild-clay potential
Weak indication
Weak indication: no layer of Galloway shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Galloway soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Galloway spot on the map
Rated from the USDA soil survey record for Galloway loamy sand, 0 to 5 percent slopes (Salem County, New Jersey) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 6% clay.
- Lowers the potential Low engineering plasticity index (3): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 16 in (41 cm)).
- Note Typically starts about 36 in (91 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 10% by volume).
Layer by layer
- TopsoilA A loamy sand layer about 0 to 2 in down: about 7% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerE A loamy sand layer about 2 to 10 in down: about 7% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerBw1 A loamy sand layer about 10 to 24 in down: about 7% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
- Sandy layerBw2 A loamy sand layer about 24 to 36 in down: about 7% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
- Sandy layerCg1best layer A sand layer about 36 to 52 in down: about 6% clay, low plasticity when wet, white when moist. Weak indication
- Sandy layerCg2 A sand layer about 52 to 60 in down: about 6% clay, low plasticity when wet, white when moist. Weak indication
What it looks like raw
The sandy layer (Cg1), 36 to 52 in down in the typical profile: white (2.5Y 8/2); gravelly sand; loose; nonsticky, nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: unconsolidated sandy marine deposits.
- USDA family particle-size class: not used.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in New Jersey, in these survey areas: Salem County, New Jersey.
By state: wild clay in New Jersey.
USDA, geographic setting: Landscape: Coastal Plain uplands
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Adelphia: Possible
- Mannington: Possible
- Mattapex: Possible
- Othello: Possible
- Sassafras: Possible
- Sharptown: Possible
- Swedesboro: Possible
- Woodstown: Possible
See it on the map
Open a Galloway spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Galloway loamy sand, 0 to 5 percent slopes, map unit GamB in Salem County, New Jersey.
- Official Series Description: Galloway(revised 11/2015), established.
- Taxonomic class: Mesic, coated Aquic Quartzipsamments
- Rated with rule version 2026-09-28.1; the method is on the About page.