Francis soil
Wild-clay potential
Weak indication
Weak indication: no layer of Francis shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Francis soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Francis spot on the map
Rated from the USDA soil survey record for Francis loamy fine sand, 3 to 6 percent slopes (Box Elder County, Utah, Eastern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 7% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 33 in (83 cm)).
- Note Typically starts about 27 in (69 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 2% by volume).
Layer by layer
- TopsoilAp A loamy fine sand layer about 0 to 7 in down: about 7% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- TopsoilA1 A loamy sand layer about 7 to 20 in down: about 7% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerC1 A loamy sand layer about 20 to 27 in down: about 7% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerC2best layer A loamy sand layer about 27 to 60 in down: about 7% clay, low plasticity when wet, brown when moist. Weak indication
What it looks like raw
The sandy layer (C2), 27 to 60 in down in the typical profile: brown (7.5YR 5/4), brown (7.5YR 4/4) moist; loose, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: Lacustrine deposits derived from quartzite, gneiss, schist, sandstone, and granite.
- USDA family mineralogy: mixed.
- USDA family particle-size class: sandy.
- Drainage: somewhat excessively drained.
Where it is mapped
Seen on the map as the most common soil in 7 map units in Utah, in these survey areas: Box Elder County, Utah, Eastern Part; Davis-Weber Area, Utah.
By state: wild clay in Utah.
USDA, distribution and extent: Northwestern Utah. These soils are not extensive with about 5,500 acres of the series mapped to date. MLRA 28A.
USDA, geographic setting: Francis soils are on lake terraces. Slopes range from 0 to 50 percent. These soils have formed in lacustrine materials that have been reworked by wind. The materials are derived from quartzite, gneiss, granite, and sandstone and are noncalcareous. The climate is moist subhumid, with an average annual precipitation from 16 to 20 inches. The mean annual temperature ranges from 47 to 51 degrees F., and the mean summer temperature is from 68 to 73 degrees F. The frost-free period is 140 to 175 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Eimarsh: Strong lead
- Payson: Strong lead
- Pintailake: Strong lead
- Saltair: Strong lead
- Woods Cross: Strong lead
- Abbott: Strong lead
- Airport: Strong lead
- Collett: Strong lead
See it on the map
Open a Francis spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Francis loamy fine sand, 3 to 6 percent slopes, map unit FsB in Box Elder County, Utah, Eastern Part.
- Official Series Description: Francis(revised 02/2006), established.
- Taxonomic class: Mixed, mesic Psammentic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.