Ford soil
Wild-clay potential
Possible
Possible: a surface layer with some clay typically about 0 to 9 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Ford soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Ford loam, 0 to 1 percent slopes (Davis-Weber Area, Utah) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 20% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (13).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Moderate thickness (about 9 in (23 cm)).
- Note Typically starts within about 0 in (0 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note Surface layer; expect roots and organic matter.
- Note USDA reports about 11% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilA1best layer A loam layer about 0 to 9 in down: about 20% clay, moderate plasticity when wet, grayish brown when moist. Possible
- Loamy layerC1ca A loam layer about 9 to 16 in down: about 20% clay, moderate plasticity when wet, light brownish gray when moist. Possible
- Sandy layerC2ca A fine sandy loam layer about 16 to 34 in down: about 15% clay, moderate plasticity when wet, pinkish gray when moist. Weak indication
- C3cam An indurated layer about 34 to 44 in down: USDA gives no clay percentage or texture for it. Not enough data
- Sandy layerC4ca A fine sandy loam layer about 44 to 52 in down: about 15% clay, moderate plasticity when wet, pinkish gray when moist. Weak indication
- C5cam An indurated layer about 52 to 60 in down: USDA gives no clay percentage or texture for it. Not enough data
What it looks like raw
The topsoil (A1), 0 to 9 in down in the typical profile: grayish brown (10YR 5/2), very dark grayish brown (10YR 3/2) moist; slightly hard, very friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: lacustrine deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Utah, in these survey areas: Davis-Weber Area, Utah.
By state: wild clay in Utah.
USDA, distribution and extent: Northwestern Utah. These soils are not extensive with about 3,000 acres of the series mapped to date. MLRA 28A.
USDA, geographic setting: Ford soils are on smooth to undulating low lake terraces. These soils formed in alluvium and lacustrine deposits derived from limestone, quartzite, and gneiss. Slopes are 0 to 1 percent. Elevations range from 4,200 to 4,300 feet. The climate is dry subhumid with a mean annual precipitation of 14 to 16 inches. The mean annual temperature is 45 to 51 degrees F. and the average summer temperature is 68 to 73 degrees F. The frost-free period is 130 to 175 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Abbott: Strong lead
- Airport: Strong lead
- Eimarsh: Strong lead
- Kirkham: Strong lead
- Payson: Strong lead
- Pintailake: Strong lead
- Saltair: Strong lead
- Woods Cross: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Ford loam, 0 to 1 percent slopes, map unit Fa in Davis-Weber Area, Utah.
- Official Series Description: Ford(revised 02/2006), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, mesic Petrocalcic Palexerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.