Flofeather soil
Wild-clay potential
Weak indication
Weak indication: no layer of Flofeather shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Flofeather soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Flofeather spot on the map
Rated from the USDA soil survey record for Flofeather sandy loam, 1 to 3 percent slopes (Ada County, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 12% clay.
- Note Moderate engineering plasticity index (7).
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 15 in (38 cm)).
- Note Typically starts within about 7 in (18 cm) of the surface.
- Note Few rock fragments (about 5% by volume).
- Note Surface layer; expect roots and organic matter.
Layer by layer
- TopsoilA1 A sandy loam layer about 0 to 7 in down: about 11% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
- TopsoilA2best layer A sandy loam layer about 7 to 22 in down: about 12% clay, moderate plasticity when wet, dark gray when moist. Weak indication
- Sandy layerBw1 A sandy loam layer about 22 to 30 in down: about 13% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerBw2 A sandy loam layer about 30 to 41 in down: about 13% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerBC A fine gravelly sandy loam layer about 41 to 48 in down: about 10% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerC A fine gravelly sandy loam layer about 48 to 60 in down: about 10% clay, low plasticity when wet, pale brown when moist. Weak indication
What it looks like raw
The topsoil (A2), 7 to 22 in down in the typical profile: dark gray (10YR 4/1), black (10YR 2/1) moist; soft, very friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: coarse-loamy alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: somewhat excessively drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Idaho, in these survey areas: Ada County, Idaho.
By state: wild clay in Idaho.
USDA, distribution and extent: Southwestern and west-central Idaho. MLRA 10 and 11. Flofeather soils are not extensive.
USDA, geographic setting: Flofeather soils are nearly level to moderately steep on flood-plain steps, stream terraces and alluvial fans at elevations of 2,500 to 3,750 feet. Slopes range from 1 to 25 percent. These soils formed in alluvium from lacustrine deposits and granitic rocks. Average annual precipitation ranges from 12 to 16 inches. Average annual temperature ranges from 49 to 51 degrees F. Frost-free period is 130 to 150 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Aldape: Strong lead
- Aradaran: Strong lead
- Bowns: Strong lead
- Breadloaf: Strong lead
- Brent: Strong lead
- Castlerock: Strong lead
- Catchell: Strong lead
- Chardoton: Strong lead
See it on the map
Open a Flofeather spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Flofeather sandy loam, 1 to 3 percent slopes, map unit 1006 in Ada County, Idaho.
- Official Series Description: Flofeather(revised 04/2006), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, mesic Cumulic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.