Felan soil
Wild-clay potential
Weak indication
Weak indication: no layer of Felan shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Felan soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Felan gravelly ashy silt loam, 30 to 60 percent slopes (Missoula County Area, Montana) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 15% clay.
- Lowers the potential Low engineering plasticity index (5): little plastic behavior expected when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 25 in (64 cm)).
- Note Typically starts within about 10 in (25 cm) of the surface.
- Lowers the potential High rock content (about 47% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Organic top layerOi An organic top layer about 0 to 2 in down, not a clay body. Weak indication
- Sandy layerBw A gravelly ashy silt loam layer about 2 to 10 in down: about 15% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
- Sandy layer2Ebest layer A very gravelly silt loam layer about 10 to 35 in down: about 15% clay, low plasticity when wet, light gray when moist. Weak indication
- Clay subsoil2Bt A very gravelly loam layer about 35 to 60 in down: about 15% clay, low plasticity when wet, pale yellow when moist. Weak indication
What it looks like raw
The sandy layer (2E), 10 to 35 in down in the typical profile: light gray (2.5Y 7/2), light brownish gray (2.5Y 6/2) moist; slightly hard, friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium derived from limestone and/or argillite.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Montana, in these survey areas: Missoula County Area, Montana.
By state: wild clay in Montana.
USDA, distribution and extent: Felan soils are moderately extensive in western Montana.
USDA, geographic setting: Landform - mountains.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Crow: Strong lead
- Grassvalley: Strong lead
- Half Moon: Promising
- Bignell: Possible
- Burnt Fork: Possible
- Greenough: Possible
- Minesinger: Possible
- Alberton: Weak indication
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Felan gravelly ashy silt loam, 30 to 60 percent slopes, map unit 39 in Missoula County Area, Montana.
- Official Series Description: Felan(revised 10/1999), established.
- Taxonomic class: Loamy-skeletal, mixed, superactive Andic Haplocryalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.