Evesboro soil
Wild-clay potential
Weak indication
Weak indication: no layer of Evesboro shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Evesboro soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Evesboro spot on the map
Rated from the USDA soil survey record for Evesboro sand, 0 to 5 percent slopes (Salem County, New Jersey) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 7% clay.
- Lowers the potential Low engineering plasticity index (4): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 49 in (124 cm)).
- Note Typically starts about 31 in (79 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 3% by volume).
Layer by layer
- TopsoilA A sand layer about 0 to 4 in down: about 4% clay, low plasticity when wet, very dark grayish brown when moist. Weak indication
- TopsoilAB A sand layer about 4 to 17 in down: about 4% clay, low plasticity when wet, dark yellowish brown when moist. Weak indication
- Sandy layerBw A sand layer about 17 to 31 in down: about 4% clay, low plasticity when wet, dark yellowish brown when moist. Weak indication
- Sandy layerCbest layer A stratified loamy sand to sand layer about 31 to 80 in down: about 7% clay, low plasticity when wet, yellowish brown when moist. Weak indication
What it looks like raw
The sandy layer (C), 31 to 80 in down in the typical profile: yellowish brown (10YR 5/6); loose; loose; very friable; loose; very friable. Raw colour is not fired colour.
About the soil
- Parent material: sandy eolian deposits and/or sandy fluviomarine deposits.
- USDA family particle-size class: not used.
- Drainage: excessively drained.
Where it is mapped
Seen on the map as the most common soil in 7 map units in Maryland, New Jersey, in these survey areas: Cecil County, Maryland; Harford County Area, Maryland; Prince George's County, Maryland; Salem County, New Jersey.
By state: wild clay in Maryland,wild clay in New Jersey.
USDA, distribution and extent: Distribution: Coastal Plain of New Jersey, Delaware and Maryland
USDA, geographic setting: Landscape: Coastal Plain upland
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Christiana: Strong lead
- Lenni: Strong lead
- Montalto: Strong lead
- Watchung: Strong lead
- Howell: Strong lead
- Kelly: Strong lead
- Kinkora: Strong lead
- Magnolia: Strong lead
See it on the map
Open a Evesboro spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Evesboro sand, 0 to 5 percent slopes, map unit EveB in Salem County, New Jersey.
- Official Series Description: Evesboro(revised 06/2006), established.
- Taxonomic class: Mesic, coated Lamellic Quartzipsamments
- Rated with rule version 2026-09-28.1; the method is on the About page.