Etil soil
Wild-clay potential
Weak indication
Weak indication: no layer of Etil shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Etil soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Etil loamy sand, 1 to 6 percent slopes (Box Elder County, Utah, Eastern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 3% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 28 in (71 cm)).
- Note Typically starts about 32 in (81 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 2% by volume).
- Note USDA reports about 50% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilA A loamy sand layer about 0 to 5 in down: about 5% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layerC1 A sand layer about 5 to 11 in down: about 4% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layerC2 A sand layer about 11 to 20 in down: about 3% clay, low plasticity when wet, light gray when moist. Weak indication
- Sandy layerC3 A sand layer about 20 to 32 in down: about 3% clay, low plasticity when wet, light gray when moist. Weak indication
- Sandy layerC4best layer A coarse sand layer about 32 to 60 in down: about 3% clay, low plasticity when wet, light gray when moist. Weak indication
What it looks like raw
The sandy layer (C4), 32 to 60 in down in the typical profile: light gray (10YR 7/2), light brownish gray (10YR 6/2) moist; loose, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: beach sand and/or eolian sands derived mainly from oolites.
- USDA family mineralogy: carbonatic (lime-rich).
- USDA family particle-size class: not used.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Utah, in these survey areas: Box Elder County, Utah, Eastern Part.
By state: wild clay in Utah.
USDA, distribution and extent: Northern Utah along the Great Salt Lake. These soils are not extensive with about 2,200 acres of the series mapped to date. MLRA 28A.
USDA, geographic setting: Etil soils are on slightly elevated beach ridges along the shoreline of the Great Salt Lake. They formed in beach sand and eolian sands derived mainly from oolites (ooliths). Oolites are small, rounded, sand-sized accretionary bodies formed of concentric layers of calcium carbonate around a sand-sized nucleus of mineral or organic origin and formed in wave-agitated waters. Mineral grains derived from metamorphic and sedimentary rocks are also a component of the soil parent material. Slopes are 1 to 6 percent. Elevations range from 4,200 to 4,300 feet. The climate is semiarid with cool, moist winters and warm, dry summers. The mean annual precipitation is 8 to 10 inches, the annual...
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Collett: Strong lead
- Eimarsh: Strong lead
- Goring: Strong lead
- Lasil: Strong lead
- Manila: Strong lead
- Obray: Strong lead
- Payson: Strong lead
- Pintailake: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Etil loamy sand, 1 to 6 percent slopes, map unit ETB in Box Elder County, Utah, Eastern Part.
- Official Series Description: Etil(revised 09/2005), established.
- Taxonomic class: Carbonatic, mesic Oxyaquic Torripsamments
- Rated with rule version 2026-09-28.1; the method is on the About page.