Ercan soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 27 to 56 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Ercan soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Ercan loam, 3 to 15 percent slopes (Morgan Area, Utah - Morgan County and Part of Weber County) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 31% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (12.5).
- Raises the potential The official series description calls the wet soil moderately sticky and very plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 29 in (73 cm)).
- Note Typically starts about 27 in (69 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 6% by volume).
Layer by layer
- TopsoilA11, A12 A loam layer about 0 to 18 in down: about 23% clay, moderate plasticity when wet, dark brown when moist. Weak indication
- TopsoilA2 A fine sandy loam layer about 18 to 27 in down: about 17% clay, moderate plasticity when wet, yellowish red when moist. Weak indication
- Loamy layerB&A, B2tbest layer A clay loam layer about 27 to 56 in down: about 31% clay, moderate plasticity when wet, red when moist. Promising
- BedrockR Unweathered bedrock about 56 to 60 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (B&A, B2t), 27 to 56 in down in the typical profile: red (10R 4/6), red (10R 4/6) dry; extremely hard, firm, sticky and very plastic. Raw colour is not fired colour.
About the soil
- Parent material: colluvium and/or slope alluvium over residuum weathered from sandstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
- Lithic bedrock typically about 56 in (142 cm) down.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Utah, in these survey areas: Morgan Area, Utah - Morgan County and Part of Weber County.
By state: wild clay in Utah.
USDA, distribution and extent: Northern Utah. The series is inextensive.
USDA, geographic setting: Ercan soils are at elevations of 6,000 to 8,700 feet. They occur on mountain slopes. Slopes range from 3 to 60 percent but are dominantly 3 to 30 percent. These soils formed in residuum and colluvium weathered from sandstone. The climate is humid, and the average annual precipitation ranges from 20 to 35 inches. The mean annual temperature is 32 to 44 degrees F., and the mean summer temperature is 53 to 56 degree F. The frost free season ranges from 30 to 80 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Ant Flat: Strong lead
- Bertag: Strong lead
- Broadhead: Strong lead
- Crooked Creek: Strong lead
- Donner: Strong lead
- Hawkins: Strong lead
- Herd: Strong lead
- Isbell: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Ercan loam, 3 to 15 percent slopes, map unit ErD in Morgan Area, Utah - Morgan County and Part of Weber County.
- Official Series Description: Ercan(revised 02/1999), established.
- Taxonomic class: Fine-loamy, mixed, superactive Pachic Palecryolls
- Rated with rule version 2026-09-28.1; the method is on the About page.